Search results
-
Noise in transmission while clutch is engaged sm465
Probably the input shaft bearing,i had an a833 do the same thing a few years ado.- dusterdude
- Post #3
- Forum: Manual Transmission & Clutch
-
EFI rated fuel plumbing solution
Look up gates barrier hose,its ethanol rated- dusterdude
- Post #4
- Forum: TBI & EFI Conversions
-
IS 350 TBI compatible with E10?
E10 will not hurt your engine,however you may have to richen the jetting a bit and all of the rubber bits in your fuel system will not like it at all.- dusterdude
- Post #2
- Forum: Engine & Performance
-
Performance fuel injection system
Let me know how much you get for it so ill know how much to ask for the one i have.- dusterdude
- Post #3
- Forum: For Sale
-
85-86 ZY6 paint stripes measurements
No,i havent but i wouldnt be surprised- dusterdude
- Post #10
- Forum: Exterior
-
85-86 ZY6 paint stripes measurements
If you pm me this weekend ill measure mine for you- dusterdude
- Post #5
- Forum: Exterior
-
Got a Dodge squarebody!
Mine burning down was my fault,not dodges- dusterdude
- Post #48
- Forum: Other Vehicles
-
Got a Dodge squarebody!
I had 1977,damn good truck till i burnt it to the frame- dusterdude
- Post #29
- Forum: Other Vehicles
-
-
Changing from 16gal tank to 20gal tank.
Nothing needed,but remember you have to move the 20 gallon tank to the rear one batch of holes.hard to describe but look at the rear mounting holes and you will another 2 holes to the rear- dusterdude
- Post #4
- Forum: Tech Discussion
-
-
-
East Tennessee intro (Jeep convert to Square Body Chevy military trucks)
Welcome- dusterdude
- Post #4
- Forum: Introduction
-
Head scratchinh situation
Good questions on the distributor,ill have to get with the seller and ask.will advise when i get more info.thanks for the help.- dusterdude
- Post #11
- Forum: Tech Discussion
-
Head scratchinh situation
Would i ground the coil end to the hold down bolt on the coil too?- dusterdude
- Post #7
- Forum: Tech Discussion
-
Head scratchinh situation
Back to this issue,i am getting 12.5 volts to the wire that plugs into the coil with key on but when i crank i only get about 10.5 volts on this wire.this seems to be recent phenomenon.does anyone where i should look for the drop?thanks- dusterdude
- Post #5
- Forum: Tech Discussion
-
-
Head scratchinh situation
Redfish,that is a damn good question.ill check it out- dusterdude
- Post #4
- Forum: Tech Discussion
-
Head scratchinh situation
Ok guys,i recently installed a small cap electronic distributor with an external coil.it seems im not getting spark but,my timing light flashes when i crank the engine.im at a loss here and by the way,this is on a carbureted truck.does anyone have any ideas?- dusterdude
- Thread
- Replies: 13
- Forum: Tech Discussion
-
-
-
-
$2250 Engine Options
Powertrain products has a reman long block for 1900.00 dollars.i do not know a damn thing about their quality though.- dusterdude
- Post #2
- Forum: Engine Swaps (Gas) LS, Vortec, LT1 , etc.
-
EFI conversion back to carb?
I would think that would work- dusterdude
- Post #2
- Forum: TBI & EFI Conversions
-
Fuel Pump?
Airtex electric pumps are junk,not sure about their manual pumps- dusterdude
- Post #24
- Forum: Carb Fuel Systems
