Search results
-
Squarebody Suburban 2nd (or 3rd) Row bench in a pickup?
2nd row would be tough to use. its a 4 piece seat and the brackets would not work on truck bed. The third row seat possibly would work. Use would have to cut out the floor pockets for the seat brackets from a donor Burb. -
Rear end question
Those numbers r casting numbers. you will have to look at the right axle tube to find the code. it is stamped on frt of the tube about 3-5" outboard of the center carrier housing. From my experience it can be quicker to pull the cover than spend 30 minutes trying to clean crude and rust off of tube.- BKING33
- Post #4
- Forum: Differential & Driveline
-
2in lift with 33 or 4in with 35s
here is a pic of mine. 6" lift and 35's on a 1-ton truck.- BKING33
- Post #10
- Forum: Lifted & Off-Road Systems
-
2in lift with 33 or 4in with 35s
Would suggest 4" for 33 and 6" for 35's. 3.73 is good for 33. 4.10 for 35. If u r running over drive trans u can go 1 ratio lower.- BKING33
- Post #8
- Forum: Lifted & Off-Road Systems
-
Axle question 1/2 and 3/4 ton
There is no way to convert those to 6-lugs. Till you price out the cost of new gear sets and good locker, u might consider sticking with 8-lugs. I had a 6 lug truck with 36" tires and 4.10s. Would not recommend 6-lugs with 37s they put alot of stress on axles and gears. I actually broke a...- BKING33
- Post #6
- Forum: Differential & Driveline
-
Underhood sender and wiring pics wanted.
Best advice on your oil line is to run a #4 AN flexible hose. A lot more $ but it will last longer. You can route your temp gauge wire parallel to your valve cover.
