Search results

  1. sidschev

    wires ?

    ok ive looked real good in there for the other purple wire. no go... But i did find that that yellow wire is in fact from the ignition switch to start the truck. so all is good there now. :favorites37: i can dump that relay and solder those wires together (i don't need a safety switch i prefer...
  2. sidschev

    wires ?

    Im heading out there now to hunt those wires down.. still dont know what the yellow wire is for... ill post back to what ever i find......
  3. sidschev

    wires ?

    they (relay was a ad on for alarm system ) so its of no use . i really dont know where they used to go to there are no obvious signs of where these go to.
  4. sidschev

    wires ?

    i did notice there was two terminals empty on the neutral safety switch. but the purple wire does not go up to the steering column but down to the fuse block. i looked on my 77 truck and the neutral safety wires are purple Two of them but no yellow wire.
  5. sidschev

    Removing dent without backside access

    i bought a whole truck once just to cut out the straight metal and weld those into the dents i cut out. lots of spot welding but i :grd: all the dents were on bad corners :grd:
  6. sidschev

    Engine removal tool

    short chain and a engine hoist in my case i have a 8x8 beam out side with a chain hoist
  7. sidschev

    wires ?

    yup except i have no need for one. truck stays in back yard and dogs attack any thing that moves or breathes :grd: i do not see any obvious places these wire went to.....and i can not put the truck back together until i know where these go so i can run the truck.
  8. sidschev

    wires ?

    I was removing some kinda alarm system that some numnut installed and i have these two wires PURPLE an YELLOW pretty thick wires. They both lead to the fuse block. Question is where do they go. there on a relay right now that was part of the alarm system. If i disconnect the wires from the...
  9. sidschev

    NP203 fluid

    i thought they took autotrans fluid. my dodge did....
  10. sidschev

    Q: Vacuum Line

    yup vac for ac heat vents. I found some small 1/8 id tubing then took some shrink tube (the stuff for wires ) and shrunk a couple pieces of that on that tube then slide the 1/8 inch tubing over that for a tight fit. then you can hook it up to a vac can .... I just had to put in a new harness...
  11. sidschev

    Whats you gas mileage on your squarebody truck?

    man y'all get good milage... i get about 4 mpg maybe 5..... but my enging is shot and the carb who knows if its adjusted or not. i can drive 30 miles and burn half tank to 3/4 tank of gas and 2 quarts oil :D:Big Laugh:
  12. sidschev

    Spark plug wires

    82sbshortbed----- how do you have the choke wired and also how do you have this (circled in red) trans thingy wired Please. i need to wire up a choke and also need to get the trans switch square thingy.... Is the choke just wired to a hot ignition on
  13. sidschev

    Are front wheel bearings adjustable?

    wheel clunk as you say is bad ball joints plain an simple. replace them all
  14. sidschev

    Spark plug wires

    i bought two sets from rockauto and used some from both sets for custom wire job on my 84
  15. sidschev

    New to the square body group!

    Howdy hey from Ozarks......
  16. sidschev

    What did you pay for a square

    picked up my first one $1000 needed rear end rebuilt and had to rewire the plug wires The one with out a bed.. the second one i picked up for $325 it had an engine fire from squirrels nest under hood (women never open hoods) so far all ive had to do is cut out all the burnt wires and put gas in...
  17. sidschev

    Best value coolant pressure tester

    i bought one from harbor frieght. just used it on my new to me 84 ,thought i had a blown head gasket but turned out fine......
  18. sidschev

    Newbie

    Thanks for the welcomes. ya i got bot rigs running . the one with no bed is a daily driver. the other one that i just picked up is in pretty good shape. just that dog gone carb is bad and i need to yank out that cat from the exhaust. in the mean time while waiting on funds for new carb im...
  19. sidschev

    Newbie

    Howdy hey . name is sid (call me what cha like just not late fer dinner ) thanks for letting me in the door Ive two trucks one a 77 chevy no bed oil burner and a 84 gmc just picked up for $325 had an engine fire. currently got it running. but it burned up a lot of rubber stuff . pulled the...
View older results

Latest posts

Forum statistics

Threads
45,558
Posts
986,224
Members
38,643
Latest member
Hard
Top