You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Search results
-
D
Need to replace rubber fuel lines on top of both tanks….
Yes but how do you get the three hoses attached on the top?? Thanks in advance- Dukester68
- Post #13
- Forum: Carb Fuel Systems
-
D
Need to replace rubber fuel lines on top of both tanks….
Thank you! Bed off or backed out this week!- Dukester68
- Post #12
- Forum: Carb Fuel Systems
-
D
Need to replace rubber fuel lines on top of both tanks….
Hey everyone… my fuel lines (rubber) are cracked and leaking at the top of the tanks and i can see them at the gap between the can and bed. My question is, is it easier to drop the tanks are raise the bed to fix these hoses? Also since im in there is it best to go ahead and replace the sending...- Dukester68
- Thread
- Replies: 52
- Forum: Carb Fuel Systems
-
D
No accessories power
This is exactly what i was looking for sir! I am going to replace the switch first because it’s easier lol however now i know this might eventually be the task. I did find that i can adjust the rod to get the accessories but not the ignition and the other way around so im going to try the switch...- Dukester68
- Post #32
- Forum: Electrical & Audio
-
D
No accessories power
This is amazing thank you for the info and yes… you have a nice theft deterrent lol- Dukester68
- Post #31
- Forum: Electrical & Audio
-
D
No accessories power
Ok i have narrowed it down to the switch. I did try adjusting it to where i actually had accessories so i know now it is possible. Lol. However when i put everything back together i went to start it and it didn’t engage the starter. I couldn’t find the sweet spot for both. It was one or the...- Dukester68
- Post #30
- Forum: Electrical & Audio
-
D
No accessories power
Hey Ricko1966… when you say switch are you talking about the key switch or the switch at the end of the rod farther down the column. I am going back in there today as now it sticks a little when starting so i need to lube that a bit. I will check this. I will get back and thx for your help!- Dukester68
- Post #26
- Forum: Electrical & Audio
-
D
No accessories power
Man i got into that column today and that was a job. I got as far as pulling the turn signal harness as far as i could and realized it was going to be a job. How in the world do you get enough slack to pull that column? I pulled the plug apart that the signal wires were attached to and it didn’t...- Dukester68
- Post #24
- Forum: Electrical & Audio
-
D
No accessories power
Yes you are correct!!! I went back in because i tore into tge steering column and got no happiness there. I did adjust it to where i got the accessory power but then the ignition switch didn’t work. I went back and forth and finally figured i need a switch…. Do you think that will help my...- Dukester68
- Post #21
- Forum: Electrical & Audio
-
D
No accessories power
I located this switch however the only adjustment i found was the hi lo beam switch. None in the ignition but i did use bent needle nose to gently force the rod back about an 1/8 of an inch and the accessories did come on. Im thinking my problem is in the gear off of the switch?? Im going into...- Dukester68
- Post #18
- Forum: Electrical & Audio
-
D
No accessories power
How is this procedure performed? Thank you- Dukester68
- Post #14
- Forum: Electrical & Audio
-
D
No accessories power
Thx for the quick response to my question! You guys rock!!- Dukester68
- Post #11
- Forum: Electrical & Audio
-
D
No accessories power
Is there a separate fuse for accessory position? Thx in advance- Dukester68
- Post #10
- Forum: Electrical & Audio
-
D
No accessories power
I will try locating this adjustment today and see whats going on. Thank you!- Dukester68
- Post #9
- Forum: Electrical & Audio
-
D
No accessories power
Thanks i will try this today but everything works in the run position and dead in the accessory position.- Dukester68
- Post #8
- Forum: Electrical & Audio
-
D
No accessories power
Radio works in run position but everything is dead in accessories position- Dukester68
- Post #7
- Forum: Electrical & Audio
-
D
No accessories power
Hello Jgonick… nothing in the accessories position but everything in the run position. I will check fuses today and thank you!- Dukester68
- Post #6
- Forum: Electrical & Audio
-
D
No accessories power
Good morning! Fairly new to this site but my first post… I have a nice 1986 GMC Sierra 2500 that is pretty much a basic truck off the lot. We inherited it from my former father in law and are bringing it back to life. I need a little direction in to why i have nothing powered when switching to...- Dukester68
- Thread
- Replies: 32
- Forum: Electrical & Audio
-
D
Great to be a part of this group!
Happy to be here! My wife and myself recently inherited he dads 1986 GMC Sierra C2500 and are looking forward to getting it back on the road!! Thanks for having us!- Dukester68
- Thread
- Replies: 14
- Forum: Introduction