Search results

  1. SquareRoot

    Swapped to 4x4, now the truck dances all over the road

    And just like that....:worthy:
  2. SquareRoot

    87 SILVERADO WITH AN 78 350 BORD 40 OVER WILL NOT STAY RUNNING AFTER SEAFOM

    The timing was not off by much to cause what was going on because it was running perfectly fine till I got gas and added the seafood Damn auto correct lol and yea I'm on my second tank I also but a dryer throught the gas to try to help with water if there was any :suicide:
  3. SquareRoot

    Turbine wheels in 5x5?

    They are in the Witness Protection Program along with round pattern 205's, hydraulic clutch pedals and 10mm sockets.
  4. SquareRoot

    Manual transmission swap

    Take a deep breath and go to Advanced Adapters. They have kits. Buy once-cry once. I have pedals.
  5. SquareRoot

    Should my TBI's fuel pressure act like this?

    No. It should prime and hold some pressure until key is turned off. It will slowly bleed off afterwards.
  6. SquareRoot

    Parking Brake Cable Upgrade

    Well, the passenger side will be about 6 foot longer than the driver side in that case. When you make the 90 degree bend at the "center axle" you gonna use a pulley or what? Steel cable don't like being bent at sharp angles. Plus, the cable enters the backing plate at a slight forward angle, you...
  7. SquareRoot

    Manual transmission swap

    I know someone who has those hard to find parts ;)
  8. SquareRoot

    Fuel filler issue. This can’t be right.

    Pocatello. I have twin brothers. One lives in Twin. So I guess I have half a twin in Twin.
  9. SquareRoot

    Fuel filler issue. This can’t be right.

    Actually, I have a LQ9 at my brothers house in Idaho and I'm looking for a 70's Pinto to tub and drop it in as my next crazy project.
  10. SquareRoot

    Acquired an 84 K30 parts truck

    On second thought, I'm not sure that these holes are for trim but rather a wheel well molding. They are only present on the rear not the front fenders.
  11. SquareRoot

    Acquired an 84 K30 parts truck

    Bill, thanks for the info. Is there seal sealer or adhesive on the joints? I assume they are lap joints but my question is after removing the bolts will the pieces just come apart easily?
  12. SquareRoot

    Parking Brake Cable Upgrade

    If you eliminate the eyelet system how you plan on hooking up two brake assemblies to one brake pedal and routing it around the driveshaft and aXLe?
  13. SquareRoot

    Fuel filler issue. This can’t be right.

    Buy a Prius
  14. SquareRoot

    Fuel filler issue. This can’t be right.

    @Keith Seymore got some splaynin to do I reckon?
  15. SquareRoot

    Acquired an 84 K30 parts truck

    A few more.. The homemade body lift is entertaining. Lol. Pieces of square or round tubing. Get r done
  16. SquareRoot

    Acquired an 84 K30 parts truck

    My buddy bought this for the axles for $1500. In exchange for setting up the axles for his K5, I'm taking the bed. It's perfectly straight and rust free (S. Cali). The bed is going on my 86 K20. My truck was t-boned long before I bought it. I have checked the frame every way possible and there...
  17. SquareRoot

    Manual transmission swap

    Hi. There might be minor differences in the transmission years, I don't know but someone will. I know about 205 t-cases and NV4500's and auto to manual conversions. Do you plan on a mechanical or hydraulic linkage? 85-87 came OEM with hydraulic you know. Do you have the pedal assembly yet...
  18. SquareRoot

    Gas tank swap

    :oops:
  19. SquareRoot

    Nv4500 ‘rattle’ between acceleration and deceleration…

    Nobody likes that except for those with unresolved childhood issues. Glad you got it figured out. I'll take a CV any day weather it "needs" it or not.
  20. SquareRoot

    Nv4500 ‘rattle’ between acceleration and deceleration…

    If the driveshaft fixed the tranny screaming at me issue the tranny wasn't the problem. On the side, that's a nice looking paint job from what I can tell.
  21. SquareRoot

    opinions on my LS swap setup

    Thumbs down for mating a 6.0 to a Colorado transmission unless there's something I don't know about. Thumbs up for spelling axle correct. We're gonna need pictures of this Frankenstein.
  22. SquareRoot

    What truck,what year,what engine,etc. Hall of Shame

    Lol. The problem with that is it's usually committed by "drive by" posters looking for a quick answer because they're too lazy to Google it. As fast as they show up, they're gone, never to be heard again. I'm already on edge lately knowing a certain "teacher" is waiting for me to misspell something.
  23. SquareRoot

    Nv4500 ‘rattle’ between acceleration and deceleration…

    You're measuring driveshaft slope. You need to measure off the u joint caps at the front and rear of the shaft. The difference is the u joint angle. Should be 3-4 degrees. A 4500 with a 208 slip case means a short driveshaft in a blazer. Even worse if it's lifted. If that's the case, I almost...
  24. SquareRoot

    Nv4500 ‘rattle’ between acceleration and deceleration…

    You're measuring driveshaft slope. You need to measure of the u joint caps at the front and rear of the shaft. The difference is the u joint angle. Should be 3-4 degrees.
  25. SquareRoot

    "Overheating" --> Now Fuel Delivery Issue --> Dirty Tank?

    No
View older results

Latest posts

Forum statistics

Threads
45,558
Posts
986,223
Members
38,643
Latest member
Hard
Top