Search results
-
P
Advice 94, Z-71, 1/2 ton Rear Diff locker install
I believe that G80 and G86 are the rpo you would see on the glove box label if it is factory limited slip or positraction- Poppy 87
- Post #4
- Forum: Differential & Driveline
-
P
What new tools have you got lately?
Cool, what transmission are you gonna build Jeremy? -
P
hard crank (broken starter?) issues
Erick, hope that is all correct with your truck, but I doubt timing caused broken starter housing. Need to correct root cause of failure. Agree with starter brace concern. Good luck- Poppy 87
- Post #19
- Forum: Engine & Performance
-
P
'97 350 Lt1 putting in an '87 gmc
You will need a longer throttle cable as well as trans detent cable. You will also want a fuel filter that will support the higher pressure, no biggie. Headers may be iffy as the LT1 has D shaped exhaust ports, might have to change exhaust flange not positive though. Good luck- Poppy 87
- Post #18
- Forum: Engine Swaps (Gas) LS, Vortec, LT1 , etc.
-
P
New member from southern Maryland
Welcome from Georgia!! Sent from my XT1254 using Tapatalk- Poppy 87
- Post #10
- Forum: Introduction
-
P
What have you done to your square lately??
Removed the 3 engines, 2 engine stands, and 4 tires from the truck bed and put into the garage. Took Ole Bessie out on a beer run! Holy glazed brakes, she hasn't been driven other than loading onto the trailer when we moved. Damn near wrecked. Washed the windshield at the gas station so I can... -
P
What have you done to your square lately??
Pull that piston and measure depth of damage. Perhaps a re-bore or sleeve will be required -
P
Keep Frying HEI Coils PLEASE HELP!
Perhaps using an analog meter, but a typical dvom when measure resistance will indicate : Ol=open circuit, .2,1,etc=continuity in ohms, or 0=short circuit. At which point you can determine if short to power or ground or internal fault Sent from my XT1254 using Tapatalk- Poppy 87
- Post #26
- Forum: Tech Discussion
-
P
Keep Frying HEI Coils PLEASE HELP!
Slow down, do you realize Zero ohm indicate short? If you are measuring continuity there will be some measure of resistance. I don't like throwing parts at a concern, but make sure you understand what you are reading during diagnosis. Good luck- Poppy 87
- Post #23
- Forum: Tech Discussion
-
P
What have you done to your square lately??
Wire em up. Brother you are going to need lights if you evacuate. Save the square! Sent from my XT1254 using Tapatalk -
P
One day builds, or quick projects
Cool, then you sold that smoker for 8k to one the folks you can't stand! Love it!! -
P
Electric fuel pump suggestions - For Carburetor
Todd- Holley blue pump near tank. Holley regulator under hood. Basic electrical, been around forever! Good luck- Poppy 87
- Post #27
- Forum: Carb Fuel Systems
-
P
One day builds, or quick projects
Damn! You all do it bigger in Texas don't you? -
P
Rear end swap, new leafs, and flip kit = shocks hitting frame
Just a wild ass guess, but doesn't axle flip drop require shock extenders?- Poppy 87
- Post #2
- Forum: Lowered & Street Systems
-
P
Dome lamp ground short circuit questions.
With vehicle in the condition, unplug 1 source at a time. If lights go out, there is the branch with the fault- Poppy 87
- Post #17
- Forum: Electrical & Audio
-
P
Dome lamp ground short circuit questions.
2 things I would verify: correct bulbs are installed and terminal tension in the fuse block. If okay, I would perform parasitic draw test and isolate each branch of the circuit(s) to determine exactly where the short is. Good luck- Poppy 87
- Post #12
- Forum: Electrical & Audio
-
P
What have you done to your square lately??
Thanks for the heads up, I had a 73 I6 3 on the tree no a/c with full shroud. Learned something today!! -
P
Smokey business
Don't forget cop brakes and cop shocks!!- Poppy 87
- Post #44
- Forum: Engine & Performance
-
P
What have you done to your square lately??
Not to nit pick too much, but I definitely recommend that you install the lower fan shroud to ensure proper cooling Sent from my XT1254 using Tapatalk -
P
What have you done to your square lately??
Nothing better than the seat of pants horsepower gains! Sent from my XT1254 using Tapatalk -
P
Just a little tip for you
Silver, copper, white, black, brown ? Been along time since a@p school in 1990- Poppy 87
- Post #17
- Forum: Tech Discussion
-
P
Advice on 2/4 lowering my c10 1974
In my research a static drop using front spindles and hangers for the rear leaf springs does not affect load capability. I would inspect vehicle to make sure nothing is broke with regards to the frame or suspension as 2 inch difference side to side seems extreme. I would probably replace both...- Poppy 87
- Post #2
- Forum: Suspension, Steering & Brakes
-
P
What have you done to your square lately??
I sure hope you flushed out the cooling system. That looks awful Sent from my XT1254 using Tapatalk
