Search results

  1. Dmack

    2.5 Rockwells is anybody running these

    I believe Vince left this board quite a while ago. Unfortunately.
  2. Dmack

    Thoughts on going down to 37s?

    I'd do.it. I can't see 2 5" in total height being that noticeable. Will give you better clearance for turning and suspension cycling as a bonus too.
  3. Dmack

    Venture a guess…

    When I got my square, there were 3 toggles . It used to be a diesel that was converted to gas. They were used for ignition and momentary start.
  4. Dmack

    Venture a guess…

    Could be anything. Best bet is to start tracing wires and see where they go.
  5. Dmack

    Gas gage reads over F when hooked up to the printed ciruit but below E when hard wired to the tank/power/ground

    3 o'clock indicates an open circuit, where 9 o'clock indicates grounded out.
  6. Dmack

    Fuel Gauge Issue

    Or the wiring
  7. Dmack

    Dash differences

    It will physically fit, but usually the wiring connector will need to be repinned to work with your harness. When I put an 84 harness into my 83 cluster, I found the wiring harness pin out diagrams , on this site iirc, and repinned it.
  8. Dmack

    Fuel Gauge Issue

    You can test the sender with an ohm meter. Pos to.the stud in the sender, neg to the body. Moving the float arm should give you a varying reading, I think from 0-90. If the sender is working, I would try replacing the wires. Gauge reading at 3 o'clock means an open circuit. 9 o'clock...
  9. Dmack

    Fuel gauge reading past full

    I may be wrong, but I believe 3 o'clock is an open circuit, while 9 o'clock is grounded out.
  10. Dmack

    What size tires for 4 inch lift?

    4" rough country lift with lt315/75R16 (34.5")
  11. Dmack

    Oil pan leak rear of engine

    Mine had a horrendous leak at the oil pressure sending unit near the distributor when I got it. Ruined the clutch disc.
  12. Dmack

    How much for my old bed?

    I guess we are fortunate in the PNW. You can routinely get a straight, rust-free lwb for $3-400. I got mine about 4 yrs ago for $175.
  13. Dmack

    Back yet again with an electrical problem

    I would try jumping the starter solenoid. That should narrow it down to a bad starter or the wiring going to it. On the clutch, when I replaced my clutch master, I had to pull the whole system out and bleed it on a bench ti get all the air out
  14. Dmack

    Headlights are messed up

    Dimmer switch?
  15. Dmack

    Do not buy a cheap generic Edelbrock rebuild kit

    I have had good luck with the Walker kits. I've done several and haven't had any issues. Generally $25-30.
  16. Dmack

    Dual Tank Switch Problem

    Usually, the gauge pegged past full is an indicator of an open circuit.
  17. Dmack

    Looking for a decent bench seat cover that doesn't break the bank...

    It is held on with several straps with plastic buckles on them, and woven laces on the sides to cinch them tight. Probably the only seat covers I have ever used that don't come loose, ever. Fairly easy to remove.
  18. Dmack

    Looking for a decent bench seat cover that doesn't break the bank...

    https://www.basspro.com/shop/en/cabelas-trailgear-low-back-seat-covers?hvarAID=shopping_googleproductextensions&ds_e=GOOGLE&ds_c=BPS%7CShopping%7CPMax%7CProprietary%7CGeneral%7CNAud%7CNVol%7CNMT&gclid=CjwKCAjwjMiiBhA4EiwAZe6jQ8OboRDFYtJmqgqyRc6w8AGRmYLLzsPF18Yt9EyoXlO-2WpecbpS2RoCYCIQAvD_BwE&gcls...
  19. Dmack

    69 C10

    Nice
  20. Dmack

    69 C10

    Nice. What are your plans for It? Just pulled parts off a 70 and trashed the rest. Saying it was rough is an understatement.
  21. Dmack

    New Air Compressor

    I picked up a couple of Husky 7hp 60gal an CL several years ago for $200ea. One for the shop and one for the garage. Much quieter and more useful than the oilless Craftsman I had for years.
  22. Dmack

    Need some Expertize for paint job

    Guess it depends. When I did my K20, I did the interior and complete exterior, minus the inside of the bed (raptor liner ). It took one gallon of color and one gallon of clear. When doing 2 stage, you thin the paint 2-1, so you get 2 gallons of sprayable product.
  23. Dmack

    6" lift what wheel and tire size can I fit? I want 35's but don't know how wide of a tire and rim i can fit.

    I have the same 315/75R16 on my 83 K20 with a 4" Rough Country lift. I believe they are considered a 34" tall tire. No rubbing. It's my dd and I'm not an avid off-roader, so i dont know what hapoens when you flex it out.
  24. Dmack

    Adhesive remover

    Any reason you don't want to use the eraser wheel? I used one on the old trim adhesive on a bed I painted and it worked fine.
  25. Dmack

    69 C10

    Nice progress. I haven't made much progress on my 70 for the last year. It actually had 2x4s for rockers. Lots of patch panels, which I luckily got before all the supplies dried up. Keep up the good work.

Latest posts

Forum statistics

Threads
48,673
Posts
1,074,336
Members
43,347
Latest member
mo4154
Top