Search results
-
-
"New Type Braided" Transmission Dipsticks
I’ve used Fitzall a couple of times with good results. Doesn’t mount to the firewall though. At least the ones I got didn’t.- brooksman9
- Post #3
- Forum: Automatic Transmission
-
-
-
Howdy from Texas!!
Welcome. 2002 doesn’t seem like 22years ago.- brooksman9
- Post #6
- Forum: Introduction
-
What have you done to your square lately??
Strippin' in the back yard!- brooksman9
- Post #20,875
- Forum: Garage
-
-
Wheel help/opinions
Going to stick with the AR61’s. They will look good against the black.- brooksman9
- Post #24
- Forum: Wheels and Tires
-
Wheel help/opinions
Yep. 2" drop shackles in the back and 1 coil cut in the front.- brooksman9
- Post #22
- Forum: Wheels and Tires
-
Wheel help/opinions
Thanks for the pics. That helps. I'm not quite as low so I plan to stick with the 60's. I think the 235/70-15 I plan to go with on the front will fit similarly to the rear with tire to rim width ratio. Should both look pretty vertical. Just need to get some more body work done and then I will...- brooksman9
- Post #20
- Forum: Wheels and Tires
-
Wheel help/opinions
Ok, trying to get an idea of how the 10" 275/60-15 might look on the back. Side wall would be a little more vertical on it but I think the depth would be about right. This is the 275 on an 8" wheel off of my Camaro. Bolt pattern is different so I can't mount it but setting up against the studs...- brooksman9
- Post #18
- Forum: Wheels and Tires
-
-
-
-
Cowl Induction or stock?
That truck looked very nice before it got smacked. Not digging the wheels. Either hood would look good. I hate hood ornaments. Just my opinion. Hope you get it fixed back up soon.- brooksman9
- Post #8
- Forum: Exterior
-
Steering Wheel Cleaning
Used some Dawn spray foam on one yesterday. Worked fairly well.- brooksman9
- Post #6
- Forum: Interior
-
-
-
New NVU Gauges
Will those fit in stock locations? Never done any gauges yet.- brooksman9
- Post #6
- Forum: Gauge, Speedo & Instrumentation
-
-
What have you done to your square lately??
Didn't take any pics but installed a catalytic converter ( 8" Flowmaster ) and sway bar disconnect kit on the K10 today. Wanted to take a back wheel off the Camaro and put up against the C10 to get some rough ideas on sizing but I couldn't find the wheel lock key. :mad: I did at least find the...- brooksman9
- Post #20,770
- Forum: Garage
-
-
-
Ferd for my Granddaughter
I have some kind of old Ford q-jet (I think) carb that was on my c10 when I got it. If anyone have a use for it it is theirs.- brooksman9
- Post #9
- Forum: Other Vehicles
-
3M Tape on cab moldings
They make special trim screw you can use to put the molding clips on if you desire to go that route. They would take the place of the little posts. Same as for windshield molding. You can get them on ebay cheap.- brooksman9
- Post #9
- Forum: Exterior
