Search results

  1. Mango

    Intake Manifold Install

    @RustyNail Double Dingo How to keep the fuel lines out of the way
  2. Mango

    Intake Manifold Install

    @DoubleDingo when you repaired, replaced the RTV did you install new gaskets or use the same ones? I did not let it set long enough before torquing the bolts, let it sit for a day before running it no leaks at the time Thanks
  3. Mango

    Intake Manifold Install

    @DoubleDingo Grey FelPro RTV going to use black next time and get the fuel lines out of the way somehow
  4. Mango

    Intake Manifold Install

    @Rusty Nail Checked it seems like the RTV failed in the back Looking into it oil coming down both sides Should just pull it off and clean the RTV use black RTV and put it back using same gaskets?
  5. Mango

    Intake Manifold Install

    Not my 396, I have a 350 all stock
  6. Mango

    Intake Manifold Install

    Yes I had leaks Checked Dist base and oil pressure sender found leak with a Bora Scope Still Have Leaks Oil Pan or Rear Main
  7. Mango

    Intake Manifold Install

    Oh ****! Seems i have a oil leak in the back left side, Possibly RTV sliped off when installing Manifold? Dam fuel lines in the way will have to do it over again this time should be easer and faster! What to do with those pesky fuel lines Will check if oil is comming from someplace else
  8. Mango

    Oil Pan Gasket

    Fel-Pro Gasket Install should I also replace bolts with new ones
  9. Mango

    Burning Oil At Start Ups

    I Have been getting blue smoke at start ups and getting worse! I have been told running rich O2 sensor Valve seals Piston Rings Running great shut down let it sit for a few,start up no blue smoke 199,000 miles all original Oil Additives? Complete engine rebuild?
  10. Mango

    Intake Manifold Install

    So Far still no codes The Beast Rides Again
  11. Mango

    Has anyone bought the LMC dash?

    I installed a Skin Last Summer Fit pretty good so far no warpage, i ordered Gray and they sent light blue
  12. Mango

    Oil Pan Gasket

    Thanks I also dented the oil pan a while back replacing the engine motor mounts. May have caused a very weeoing leak? Should i also install a New Oil Pan?
  13. Mango

    SOLVED! 1987 350 TBI Timing advance issues

    Great I had some of the same issues What a Pain
  14. Mango

    Steering slop

    Do Not adjust the Red Head will Void the Warranty, Check if your Rag Joint is not worn out, If it has one ?
  15. Mango

    What did you pay for a square

    $300. for a Old School District Burb it probably help that I work in the Shop, Put some time and money $ 4,500 so far in making it road worthy, still have issues but get from point A to B
  16. Mango

    Ran yesterday but not today… just bought it yesterday!

    That is for a Vacuum line for the EGR Solenoid, see if you have a EGR valve
  17. Mango

    Oil Pan Gasket

    How to tell if oil pan is leaking or Rear Main Seal
  18. Mango

    Air Filter

    I never had the OEM air cleaner it was not there when i purchased it, Expensive replacement Searching salvage yards Any Leads?
  19. Mango

    Air Filter

    Hey All What air filters are you using? OEM with tube, tube removed and cove flipped over open filter,
  20. Mango

    Intake Manifold Install

    @gmbellew Think I Got it, Changed the Tan/Black by pass Connection and secured the tach wire that may have been grounding out? Cleared codes 16 mile test drive no service engine light Thanks for all your wisdom
  21. Mango

    Rear Axel Bearings and Seal

    @PrairieDrifter Copy
  22. Mango

    Intake Manifold Install

    @Rusty Nail I am just about to do that! Black out lot of dash lights on a school bus, Like Regen Needed ...
  23. Mango

    Rear Axel Bearings and Seal

    Prairie Drifter, Did you use a gasket or RTV?
  24. Mango

    Intake Manifold Install

    Not a New Wire Harness, Just two wires ICM to ECM Solder or butt connectors with heat shrink
  25. Mango

    Intake Manifold Install

    Would it be easier to just replace the wires rather than mess with a 34 year old wiring harness ICM to ECM ECM plugs are good I will check the short run to the firewall and for plug wires that may be too close. The large harness is behind the engine almost impossible to reach Thank You

Latest posts

Forum statistics

Threads
48,666
Posts
1,074,187
Members
43,340
Latest member
hauto85
Top