Search results

  1. SquareRoot

    SM465 LS MANUAL SWAP

    Trying to get into Edelbrocks mindset. So far, it's a no-go. Lol
  2. SquareRoot

    K5 3” lift question

    Gas at $3/gallon and 3000 miles? Ya, makes perfect sense.
  3. SquareRoot

    Diagnosing mysterious sound from Tran/Tcase

    That doesn't look bad. That slight play will be taken up when you torque the retaining nut down. When you put the output shaft assembly back together, make sure there is zero movement in it. If I remember correctly, I was torquing the yoke retaining nut down on the bench and then putting the...
  4. SquareRoot

    Body and frame welding needed

    Damn. That thing is in two zip codes!
  5. SquareRoot

    Bad alternator bearings

    Glazed Donuts are a different website.
  6. SquareRoot

    Need advice on how to tackle an issue on my '86 305

    At the moment, I drilled a 1/4 hole in both caps and that fixed the drivability issue. However, I can smell raw gas fumes around the vehicle and with the drivers window down. So I don't plan to leave it like that. I ordered and received a new 3 port cannister ($80) from Summit and a new check...
  7. SquareRoot

    Bad alternator bearings

    Why has nobody mentioned a "glazed" belt? I have personally glazed a brand new belt in less than 5 minutes. I don't know how you fix it other than replace it and tension it properly. If it's squealing, its slipping. If it's slipping, it's probably glazing. I don't know if glazing the belt leaves...
  8. SquareRoot

    Need advice on how to tackle an issue on my '86 305

    Regarding the pressure in the tank, I had until recently a similar issue. Although I have aftermarket EFI, I think the cause and effect are the same. Took me a long time to figure out my issue. The attached is a screenshot of my recent post on another forum.
  9. SquareRoot

    Here’s the best heavy rust dissolver for smaller parts like nuts and bolts that you’re probably not aware of and is probably in your kitchen.

    I'm a big fan of throw that Sh*t away. If ya really need it, buy another one. If they don't make it anymore, you don't need it.
  10. SquareRoot

    Oil pressure sender stuck.

    Nobody asked the OP why he was removing it. Maybe he just wanted the challenge? Mountain climbers understand.
  11. SquareRoot

    Oil pressure sender stuck.

    As proven by your profile pic.
  12. SquareRoot

    Oil pressure sender stuck.

    ^^:lol:
  13. SquareRoot

    1988 r30 with newer motor ac problems 7.4 liter

    Compressor. :Wedgie:
  14. SquareRoot

    AC Not Getting Cold

    Compressor.
  15. SquareRoot

    82 k20 front leaf spring question

    My K20 has a two inch lift (Rancho). :popcorn:
  16. SquareRoot

    Diagnosing mysterious sound from Tran/Tcase

    So on mine, it wasn't that the yoke was loose, it was tight on the output shaft. It was the output shaft that was moving with the Yoke. Cranking down that big nut is what allowed the internal shoulder on the shaft to seat that inner bearing...
  17. SquareRoot

    Diagnosing mysterious sound from Tran/Tcase

    Ok I had a similar issue when I rebuilt my 205. Drove me nuts cause I had new driveshaft as well. Make sure there is Zero lateral play in the yoke. I had like a 1/16" and dismissed it. Turned out that was the problem. There's an internal bearing on the output shaft that needs to be completely...
  18. SquareRoot

    Diagnosing mysterious sound from Tran/Tcase

    Is your 205 output shaft fixed or a slip yoke?
  19. SquareRoot

    WANTED: 1977 K5 Blazer 4x4 rear drive shaft.

    :supergay:
  20. SquareRoot

    Death wobble

    I drove a brand new 2010 F250 work truck. It had death wobble as did a few other "brand new" work trucks at the time. If it was due to bad parts, they were brand new bad parts.
  21. SquareRoot

    SM465 LS MANUAL SWAP

    Mind over matter. Love my NV4500 after taking out my TH400 and smashing it against the wall and shattering it in pieces! Best swap ever.
  22. SquareRoot

    Stockvs Ram horn manifolds

    Forget OEM. Hooker Cast headers. You can thank me later.

Latest posts

Forum statistics

Threads
48,666
Posts
1,074,176
Members
43,338
Latest member
jw23655
Top