Search results
-
Any black two tone trucks out there?
What color is the interior upholstery? I would think that would matter for your exterior color choice. -
Bowtie Brush guard.... Opinions?
Notice the bowtie that should be on the grille, isn't? Perhaps this was an attempted home-made substitute. -
Pure SEX!
Since you've started it, I'm going to offend people too. I was never very interested in Corvettes, and these third gen cars are probably the reason. Gawd knows I tried to like them because all the other kids thought they were sooooo cool. But the styling was way too gaudy and overdone for me...- Blue Ox
- Post #23
- Forum: eBay & Craiglist Listings
-
New For Me 1985 Silverado 20 6.2 Diesel
There is a switch on the pass side cylinder head. There's also a switch for the cold start timing advance and idle stepper. The problem is I don't remember which is which. I also don't remember the specifics of how it works, so I'd have to consult the manual, which I don't have handy. If you...- Blue Ox
- Post #100
- Forum: Introduction
-
New For Me 1985 Silverado 20 6.2 Diesel
Was the engine still warm when you went to restart? The glowplugs don't function if the coolant is over 100°.- Blue Ox
- Post #98
- Forum: Introduction
-
Two bad new oil pressure sensors? Tell me I am wrong.
In my experience, shorting the sensor wire to ground will peg the gauge. If it's showing full high even when not connected, something in the circuit is grounded. Although, Roger's diagram shows an open circuit doing that, so maybe an '80 is different. Either way, if it's pegging without a...- Blue Ox
- Post #5
- Forum: Gauge, Speedo & Instrumentation
-
What new tools have you got lately?
That, my friend, is brilliant! I'll be making my own very soon. Thank you. -
GVW
You should pay the GM Heritage Center a visit and download the data books for your truck. If you wade through that you'll be able to decipher all the VIN, SPID and other documents for your specs and options.- Blue Ox
- Post #9
- Forum: Tech Discussion
-
What have you done to your square lately??
That wasn't under water, was it? -
New For Me 1985 Silverado 20 6.2 Diesel
Usually "winter blend" is a lot of kerosene. I've had it happen on a couple of occasions from an unexpected cold snap, right around 15° every time. After that I started using additives in the winter. Somewhat more recently, like twenty years recently, I started using additives all the time...- Blue Ox
- Post #92
- Forum: Introduction
-
What have you done to your square lately??
Same here. We put a seat cover on ours from almost day one. Except for a seam split the original upholstery is perfect. When the truck gets redone it's getting fabric upholstery. And a seat cover. -
4wd indicator light wiring
In my experience, it won't last. Hope your experience is better than mine. :(- Blue Ox
- Post #17
- Forum: Transfer Case
-
700R4 started shifting really high RPM
Again, there's WAY better transmission guys here than me, and it's been a long time since I've had my hands in a 700R4, but IIRC, the cable moves a lever that pushes up on the valve. So, if the valve sticks the lever returns and the valve stays put. Thus the transmission thinks you're at WOT and...- Blue Ox
- Post #4
- Forum: Automatic Transmission
-
700R4 started shifting really high RPM
My guess would be that the throttle valve itself is stuck. So it's shifting on the governor, not throttle position. I believe there's a kit available with an assist spring to push the valve back. There's much better transmission people here that can probably direct you to thr correct item.- Blue Ox
- Post #2
- Forum: Automatic Transmission
-
Which A/C compressor do I have?
My '85 K20 has a DA6 and when I swapped the diesel into my '86 Suburban I used the same setup. It worked reliably for as long as I owned the truck. The Suburban had rear A/C too and the DA6 was fine. I believe they switched from the D6 to the DA6 around 1983 or so. One could do a little... -
Which A/C compressor do I have?
Yours is a DA6, and the one you're looking at is an A6. It's a better compressor, but it's also much bigger and won't fit your brackets. -
-
Small block be big block engine pedestal
The above is correct. Yes, but no. Things will bolt up, but it won't be what GM intended. I had the same issue with the diesel swap. Bigger motor mounts and different perches.- Blue Ox
- Post #5
- Forum: Engine & Performance
-
Clamp on roof rack? I'm feeling rather horny.
It's the hidden horns. I'd bet money he's one of the a-hole mall crawlers that sneaks up on people and thinks it's funny when they're scared by the horns.- Blue Ox
- Post #26
- Forum: Tech Discussion
-
What have you done to your square lately??
Moog never used to be. If it's a shadow of its former self, its frikin daylight now -
What have you done to your square lately??
I used to think I could put a paragraph together until Mr Retty started posting. -
1986 K10 wheel 4x4 decals/inserts
Auto locking hubs had a 4X4 logo on them. Usually the aftermarket ones are for the rallye wheel caps and are too big for the auto hubs. Sorry I don't have a better answer for the O.P.- Blue Ox
- Post #3
- Forum: Wheels and Tires
-
-
Clamp on roof rack? I'm feeling rather horny.
Please tell me you're not going to be one of those blow-holes that runs those things at full pressure and goes around scaring the cr@p out of people with train horns. We've got a few of them around here and I'm seriously trying to figure out where to find them and bring my own train horn to the...- Blue Ox
- Post #7
- Forum: Tech Discussion
-
Dash Brake light comes on after a couple minutes of driving
Mine has a defective switch on the combination valve that has similar symptoms. I'd just try disconnecting the wire on the valve and see what it does.- Blue Ox
- Post #11
- Forum: Suspension, Steering & Brakes
