Search results

  1. P

    56" unloaded spring height?

    im looking at a set of used multi-leaf rear springs. The are 11" unloaded ( i know they likely have more arch the thicker leaf pack). Is this likely to be a factory height or lifted? Does anyone know the stock 56" height when unloaded?
  2. P

    power steering reservoir replacement

    my sons 87 6.2 steering pump (with AC, so its got the dual return and remote reservoir) reservoir/can is rusted and leaking. They seem hard to find. Does anyone know a crossover application or source for these?
  3. P

    k5 tailgate window refurb questions

    yes, its all the way adjusted to the drivers side, which is why I was looking at the rod as being the culprit.
  4. P

    k5 tailgate window refurb questions

    is there a trick to getting the key out of the tailgate handle? Ive got the plug out of it, the two little clips on either side, but it will not push out. Does the whole assembly twist out, needing to push the weird washer flat somehow? man, its a pain the butt
  5. P

    k5 tailgate window refurb questions

    took some of the bend out of it, to get it to engage sooner. Has much more movement now. Figured I would have better opening, but the latches on the ends still only "pull" so far, so the improvement was negligible.
  6. P

    k5 tailgate window refurb questions

    also, Im guessing this "push rod" should not be so bent? It doesnt look like the one pictured on LMC is bent, but its possible its just the picture. This curve would explain why my tailgate is difficult to open. Also, how important is the safety bar with the spring at the bottom of the latch...
  7. P

    k5 tailgate window refurb questions

    ok, so only the glass runs in those, NOT the ends of the sash itself?
  8. P

    k5 tailgate window refurb questions

    great find, thank you, but youre right, the cost is almost negligible.
  9. P

    k5 tailgate window refurb questions

    the sash needs replacement. the verticals would do great with a turn in the sand blaster, but I cannot find replacement felt for them. ANyone have any ideas on where to source the felt? Im guessing the sash should fit snugly in the verticals?
  10. P

    k5 tailgate window refurb questions

    pulled my parts out. The main track is bent and rusted, so it will get replaced. The verticals are surface rust, but appear OK??? Although one end on the drivers side does apear to be bent out some, but fixable. The felt is another story however, and needs replacing IF i can find it, as LMC...
  11. P

    k5 tailgate window refurb questions

    Ive been searching quite a bit, but cant find the answers to my quandry. My son pulled the glass from his tailgate a while back, and we are trying to put everything back together. I already have new felts, new cable, new weather strip for the top, new rubber for the window glass mount. When...
  12. P

    K30 w/hydroboost clutch pedal solution

    02 internal slave nv4500 looking to put it behind a 6.2 diesel for now, until the kid an afford to put the 6.0 LS in
  13. P

    K30 w/hydroboost clutch pedal solution

    so '02 clutch,pressure and slave to match the trans? Im seeing folks using a GTO slave?
  14. P

    need 700r4 TV cable for 6.2?

    wow. very small diameter for a breather........
  15. P

    K30 w/hydroboost clutch pedal solution

    can you expand on this please?
  16. P

    need 700r4 TV cable for 6.2?

    ill try to get a picture, but its a bracket on the back of motor, square hole for cable housing to press fit into. there is about an 8" "rod" that goes from injection pump that the cable teardrop fitting attaches to.
  17. P

    need 700r4 TV cable for 6.2?

    I put a message in, but havent heard from them yet. It was shiftinig fine prior to pulling, but the kid couldnt figure out how to disconnect the little tear drop fitting, so he undid the barrel nut and pulled the cable out. I have managed to put it back to very close to how it was. How fickle...
  18. P

    need 700r4 TV cable for 6.2?

    Thank you for the link. I found the same things and looked at both those places but they say they are discontinued.
  19. P

    need 700r4 TV cable for 6.2?

    the flex plate on my sons 87 blazer cracked, in addition to all 3 bellhousing bolts on the passenger side were missing. (Not sure if they fell out recently or were not installed by PO). need less to say, when dropping the trans, looks like maybe the PO used a universal TV cable which used a...
  20. P

    6.2 accelerator cable replacement

    My sons accelerator cable frayed and stopped working on his 87 diesel blazer. We purchased a pioneer 8503 cable, and the ball detent distance from the pedal is wrong and the cable does not work. Reading on hillbilly wizard, sounds like this is a common issue, but while I was out of town, the...
  21. P

    700r4 kicking into neutral

    sons 87 k5 700r4 6.2 just tightened steering tilt bolts as they were quite loose. the trans was, and now worse, keeps kicking back into neutral from drive while running down the road. is this likely a column or linkage problem?
  22. P

    vent window interchange?

    not sure, I just know they have a 2 bolt lower mount.
  23. P

    vent window interchange?

    I found a set of rebuilt ones for not much more than I can get all the parts for. I was being lazy and considering just getting those if I could use them.
  24. P

    vent window interchange?

    thanks. any info on what the minor work would be?
  25. P

    vent window interchange?

    yes, the whole assembly. Ive seen where some things indicate they can be used interchangeably, but I dont have the two types to compare. thanks for the link. Found that yesterday when searching, but it still doesnt say if they are interchangeable

Latest posts

Forum statistics

Threads
48,413
Posts
1,066,799
Members
42,792
Latest member
WyldTinker
Top