Recent content by warrpath4x4
-
W
K5 canopy side windows that open?
check market place for a whole top, you can pick up a whole top for $100-200 and sometimes for free if you find the right deal- warrpath4x4
- Post #6
- Forum: Exterior
-
W
Cutting A-bomb front bumper
ive seen several people have to trim the sides for their winches to fit- warrpath4x4
- Post #3
- Forum: Lifted & Off-Road Systems
-
W
Happy to be here.
Yes there are, I was raised in Coos Bay till middle school- warrpath4x4
- Post #13
- Forum: Introduction
-
W
Happy to be here.
welcome from Washington (the state, not that other place) where at in Oregon are you from?- warrpath4x4
- Post #3
- Forum: Introduction
-
W
Hello
I was just through there the other week picking up an axle- warrpath4x4
- Post #18
- Forum: Introduction
-
W
Hello
Welcome from Washington (state, not that other place)- warrpath4x4
- Post #10
- Forum: Introduction
-
W
Hello from Vancouver, WA / Portland, OR
welcome from Prosser- warrpath4x4
- Post #13
- Forum: Introduction
-
W
What have you done to your square lately??
Q. What have you done to your square lately?? A. Ignored it- warrpath4x4
- Post #22,498
- Forum: Garage
-
W
Just got back into a square body
I remember seeing that truck, it was either for sale or over on CK5- warrpath4x4
- Post #8
- Forum: Introduction
-
W
SOLD
been so busy I have not bothered posting them on FB for the flakes lol but they are still available.- warrpath4x4
- Post #6
- Forum: For Sale
-
W
Alternatives to anti-sway bar?
rock jock, sky jacker, and im sure there are more, sell aftermarket sway bars that can be modified to fit a squarebody- warrpath4x4
- Post #3
- Forum: Suspension, Steering & Brakes
-
W
Looking for new tailgate. 85 K5 Blazer.
They will interchange, you just need the matching hinges and stuff from the truck. The blazer tubs are already pre drilled/tapped to bolt the hinges up- warrpath4x4
- Post #8
- Forum: Paint and Body
-
W
Looking for new tailgate. 85 K5 Blazer.
Go with a soft top and you can use a pickup tailgate- warrpath4x4
- Post #3
- Forum: Paint and Body
-
W
Reinforcing Door Striker
Unbolt the striker, use a small drill bit to drill out the end of the cracks, weld them up, grind them down, I remove one of the washers they have stacked and replace it with a fender washer that I then tack weld in several spots to the door jam. For the rattling, get some pex tubing like...- warrpath4x4
- Post #11
- Forum: Exterior
-
W
Tire suggestions for lifted 86 suburban
Ya I found a name brand shop that will do all 4 for $100 no matter what size, but if you call them on the phone they will tell you no lol- warrpath4x4
- Post #11
- Forum: Wheels and Tires
