Toad455's latest activity
-
TToad455 replied to the thread What are these holes for?.I remember that now, thank you. I think the bottom left hole may be for that as well.
-
TThe one under the large hole for the blower motor wiring is for the jute insulation, for a push in rubber retainer
-
TToad455 replied to the thread What are these holes for?.Thanks, I'll try again
-
TI took a ton of pics before disassembly but I don't see what these holes were for. I have all the rest of them accounted for but these...
-
-
TWelcome from Missouri.
-
TToad455 replied to the thread New to the Forum.Welcome from North Texas
-
THello, I just recently purchased a 1985 C10 stepside. I have restored many trucks and cars in the past. Now that I’m retired from the...
-
TToad455 reacted to idahovette's post in the thread New Hinge Alignment with NO Reference Marks with
Like.
^^^^^^^^^THANK GOD^^^^^^^^^^^^ -
TAlso, just be aware you're only going to get the A-pillar gap so good. They were junk from the factory and varied WILDLY. Here's my blue...
-
TYeah there shouldn't be any shims or washers under the hinge, either at the cab side or the door side. All your adjustment is in the...
-
TGot any pictures? I've taken several of these trucks apart and never found shims under the hinge. Inward and outward toward or away from...
-
TFinished up my LS swap (L76 aluminum block 6.0 with LS3 heads) and got it tuned. My tuner said the open element "cold air" intake I had...
-
TToad455 reacted to PrairieDrifter's post in the thread New Hinge Alignment with NO Reference Marks with Like.
You need the seals to do the alignment. Also pull the striker off the door jamb. You're gonna be taking it off and on a bunch. An engine...
-
THaving worked the the tool and die / molding industry for 20+ years, we used all kinds of ways to mark molds , patterns and castings...
-
TPossibly the casting number is for a 69-72 K20 all I could find...so far. May need to research Julian Date Code reference. See this...
