Recent content by Tim Cyrus
-
T
Do U joints have to align in any way
In addition to Turbo4Whl's link from Spicer on angle and phasing here is a good technique to insure phasing is correct.- Tim Cyrus
- Post #13
- Forum: Differential & Driveline
-
T
Quadrajet question
You may have been on track with your original post thinking the float level is to high. The higher the float level the "Sooner" the nozzles start to feed. At an idle air rate with the float level high you may get some drips of fuel out the nozzles this would be seen as a rich spike and...- Tim Cyrus
- Post #19
- Forum: Engine & Performance
