Recent content by SQ HAF KRU
-
Before and After
Its a driver....Gen 5 LS, with 4L60 trans.....Cut 1/2 ton frame and lengthened...seats are from 2014 Silverado. My wife helped a lot...Im very lucky..she was huge help with the wiring.- SQ HAF KRU
- Post #14
- Forum: Interior
-
First real drive! Not tragic but not good. I think I need carb advice.
Need more pics, with air cleaner off....then people will be able to help- SQ HAF KRU
- Post #20
- Forum: Engine & Performance
-
Exhaust kit for straight through muffler?
I even think they still make the old Thrush mufflers, and those were pretty straight through design.....- SQ HAF KRU
- Post #9
- Forum: Engine & Performance
-
Old77’s Oldest Kid’s 1992 S10 Blazer thread
S-10s are a blast....great first project. Keep us posted on progress- SQ HAF KRU
- Post #50
- Forum: Other Vehicles
-
Long Time Lurker and Finally Introducing Myself
Off to a great start, keep up the good work....everyone here will do their best to help... Keep us updated...- SQ HAF KRU
- Post #6
- Forum: Introduction
-
Accidentally bought a shortbox square body
looking forward to seeing pics,,,,,sounds interesting, 9" and a 4 link already- SQ HAF KRU
- Post #9
- Forum: Introduction
-
Rebuilt TBI 350 coolant in oil
Sounds like head gasket, or cracked head, did machine shop rebuild the heads as well???? Was the block decked? After pulling heads, make sure you have correct gaskets, there are some differences in small block gaskets, make sure all the water holes line up on both surfaces, aka heads and the block.- SQ HAF KRU
- Post #15
- Forum: Engine & Performance
-
Member From Utah
You took your time and figured out how to do all that you wanted!!! Nice job, really looks good!!!- SQ HAF KRU
- Post #11
- Forum: Introduction
-
Hej From a newbie :)
Welcome from AZ ...good looking ride, thanks for sharing pic- SQ HAF KRU
- Post #25
- Forum: Introduction
-
Hi
Us old guys need pics.....sound like a great project....looking forward to seeing more info- SQ HAF KRU
- Post #20
- Forum: Introduction
-
Hello from East Texas
Great looking burb......and the guts to make the road trip....just to cool!!!- SQ HAF KRU
- Post #17
- Forum: Introduction
-
255/60/15 vs 275/60/15
Its all about you....what do you really like.....I'm a fat and skinny guy.....its just me, some like all 4 corners the same.....I do have a site I use Tiresize.com...I enjoy it, you can select 2 sizes, and they compare them for height, width, and diameter....the diameter deal really helps on...- SQ HAF KRU
- Post #4
- Forum: Wheels and Tires
-
Hello from Oregon
All the work so far looks great....blower...too cool....keep up the great work, and keep doing well in school!!!! Make sure you tell your Dad thanks again for all his help!!- SQ HAF KRU
- Post #22
- Forum: Introduction
-
Building a new motor for my 79 C10 - would love some advice!
Ok, all good info, you said you wanted to drive on long trips, and have fun with the throttle....all great ideas. I must have missed what transmission you will be using.....if its a turbo 350 or 400.... orif you are using a 700r4 that would change rear axle ratio. The big key is the same as...- SQ HAF KRU
- Post #16
- Forum: Engine & Performance
-
C15 help
From the picture you send, it looks like all accessory belts come with engine, I don't think clearance will be an issue between the inner fender and the compressor on the passenger side. Find a shop that makes and install custom AC lines, they can make that hoses to match up all your lines very...- SQ HAF KRU
- Post #3
- Forum: Heat & AC
