Recent content by snowpro90

  1. snowpro90

    New GMSB Tattoo

    Thanks Paw Paw.
  2. snowpro90

    New GMSB Tattoo

    :sorry: should have posted in exterior thread.
  3. snowpro90

    New GMSB Tattoo

    Thanks Jacob,it looks great !
  4. snowpro90

    Old77's '98 ECSB 4x4

    Nice truck! I had a couple of these trucks and were a pleasure to work on and drive. Congrats!
  5. snowpro90

    3/8 flex head ratchet

    Besides the big name tools any recommendation? How about craftsman?
  6. snowpro90

    3/8 flex head ratchet

    I have been wanting a 3/8" flex head ratchet for some time now. I received a gift card to Lowes,so I figured I would use it on that. The 3/8 flex head was $29 by itself and on the end cap I found a spark plug kit that came with the identicle ratchet along with two spark plug sockets and a...
  7. snowpro90

    Wiper Arms Modification?

    You have my attention on this one.It's always a hassle when washing my truck.I have had other GM trucks that the wipers would flip up making it convienent to brush off the snow.
  8. snowpro90

    How To Refurbish Your Dashpad

    Nice job man and way to bring that dash back to life again.
  9. snowpro90

    Wiper delay not working

    Thank you guys!
  10. snowpro90

    Question on headliner install

    Thanks. I'm glad it's done.
  11. snowpro90

    Wiper delay not working

    Thanks Justin.
  12. snowpro90

    Wiper delay not working

    Hey! T.G.I.F. I would like to get my delay wipers working and was hoping for a little help. The hi-lo works fine but only cycles on low(slow) while in delay mode.
  13. snowpro90

    Single-Din Head Unit Installation

    Thanks Dustin! I performed surgery today after debating if I should cut the dash or not. I figured it's nobody else's truck but mine so it's done and came out great. I installed the same radio as yours I believe and sounds pretty good with the factory speakers. I also hooked up the Bluetooth...
  14. snowpro90

    Question on headliner install

    I was able to slide the headliner out and then back in from the back with it resting on the side panel trim pieces that I had pulled away and loose fitting, I did remove the rear trim piece . The rubber mat is a cut to fit pick-up truck bed liner that lays over the carpet to protect it.

Forum statistics

Threads
42,137
Posts
909,962
Members
33,637
Latest member
Mistafishe
Top