SirRobyn0's latest activity
-
SSirRobyn0 reacted to 83Stepper's post in the thread LED exterior light conversion! not going well :( with
Like.
Go back to incandescent bulbs and #1 rule of anything light/wiring related on these trucks are......say it with me class Check your... -
SSirRobyn0 replied to the thread Starter Solenoid Sticking.I completely agree and was going to say something similar. I actually just had a vehicle in the shop that went though something similar...
-
SThey usually stick due to high amperage draw,normally from a battery that's low on charge. It's OHMs law, cut the voltage in half...
-
SSirRobyn0 replied to the thread LED exterior light conversion! not going well :(.Yes, please go back to incandescent. I work at a shop and we do a lot of work on older rigs and classic. LEDs are in my opinion a...
-
SSirRobyn0 replied to the thread Intake Manifold RTV Dry Times.I would not try to reuse, simply because I think it's good self insurance that they won't leak by replacing them. I wouldn't want to do...
-
SIntake gaskets are sold separately, just need to know if rectangle or oval intake port . Take a picture to take with you to auto parts...
-
SThanks for the replies everyone!! Another quick question. When I installed the existing intake, I used a set of FelPro Vortec gaskets...
-
SThank you good sir! Considering I just blew a disc in my back 6 weeks ago, it's the only way to get this done. It's a win-win!
-
SSirRobyn0 replied to the thread Gas spilling out filler neck while driving! 1977 C-10.I'd say both of those things. Both check the fuel cap and the charcoal canister for correct operation.
-
SSirRobyn0 reacted to Frankenchevy's post in the thread Differential swap / bought it, work and install now with Like.
Same here. About a half hour of driving can yield 2-3,000’ of elevation gain. Makes towing and carb tuning a little more interesting.
-
SThat made me recall back in 2014 when I had just stabbed the engine back in the '81 and was reinstalling the passenger side exhaust...
-
SSirRobyn0 replied to the thread Differential swap / bought it, work and install now.I think I've pretty much made the decision to do just that. I'm going to bring brake shoes, hardware, wheel cylinders, axle bearings...
-
SSirRobyn0 reacted to Grit dog's post in the thread Differential swap / bought it, work and install now with Like.
Rob, considering unlike most of us, you have car lifts at your disposal, and you’re not hauling tons of turkle feed around like you...
-
SSirRobyn0 replied to the thread Intake Manifold RTV Dry Times.No, makes sure the parts are clean and assemble immediately. As far as I know the only seals with tack up times left are going to be...
-
SThanks y'all!! Regarding the right stuff, how quickly do I need to move on it? IE, I usually let reg'lar RTV tack up for a bit before...
