Ricko1966's latest activity
-
RRicko1966 reacted to DoubleDingo's post in the thread Double Dingo's 1965 3/4 Ton "Crusty Biscuit" with
Like.
Couldn't have @1low4x4 being the only one working on a 65 chevy this weekend. It's time to tear off the mangled sheet metal. Got a... -
RRicko1966 replied to the thread BBC 396 wil not idle with any carb.It's very possible,and common that the outer ring on the balancer has slipped or the wrong balancer was installed. Buy a piston stop,and...
-
RI saw on YouTube (like you suggested) bending in small increments moving the tube in 1/2 inch to 1 inch at a time it also helps to...
-
RRicko1966 replied to the thread Electric fuel pump.Running an electric pump,if you mount it in the rear and blow through the factory pump. You can maintain all your factory lines in the...
-
RRicko1966 replied to the thread Center support bearing HELP.Are you sure you aren't measuring the O.D. an inner race that is seized in place.
-
RRicko1966 replied to the thread Wiring Two subs together?.Been busy all day sorry. But I have nothing to add to what @CountKrunk said he explained wiring series vs. parallel better than I did...
-
RTo wire your Sony XM-N1002 (2-channel, 1000W amp) to two 12" subwoofers, we need to consider: Subwoofer impedance (ohms) – Are your...
-
RRicko1966 replied to the thread Frost bite radiator & electric fan???.Not to nit pick but your truck is not being restored if it's got a 3 inch lift kit,not saying it's not cool, just not restored. Another...
-
RRicko1966 replied to the thread Frost bite radiator & electric fan???.I'd try lowering and triming the shroud and running a 6.0 fan. Lots of cases where going back with a mechanical fan fixed overheating...
-
-
RYeah the factory charcoal canister is pretty slick. There is a thread on here on what each connection is for here. The short of it is...
-
RRicko1966 replied to the thread Frost bite radiator & electric fan???.A 6.0 fan
-
RRicko1966 replied to the thread Frost bite radiator & electric fan???.Most electric fans cannot move as much air as an engine driven fan,most aren't even close. If an electric fan is against the radiator no...
-
-
RRicko1966 replied to the thread Wiring Two subs together?.That looks to me like you are trying to run two speakers in parallel which would make the load 1/2 of what the speakers are labeled as...
-
RIt all depends on the block. There were certain 283s that could go an 1/8.........but NOT many that would last. I do think I have one...
-
RYes we used to bore them .125 over in the early 80s and called them 301s not realizing that made a 4 inch bore and basically a 302 like...
