Ricko1966's latest activity
-
RRicko1966 reacted to PrairieDrifter's post in the thread Update on my Ignition Module failure! with
Like.
The street fire should be the same size module as factory gm. All of the other msd stuff is all ignition box controlled which mounts on... -
RRicko1966 replied to the thread Finally got a running 65 C10.@DoubleDingo nailed it. It uses a TV cable for lime pressure and use the 4th gear switch for converter lock up,or an external pressure...
-
RIt was most commonly installed in 80's B and G body cars. Their dimensions are favorable to swap in place of a TH350 and I believe the...
-
RRicko1966 replied to the thread Finally got a running 65 C10.A 200 r4 swap would be a dirt simple,cheap,and easy 1 afternoon project,no controller required. Leave the stock pedals, with a spring...
-
-
RIt's easy and corrects a lot of bad behavior issues with the column shift.
-
RAlso, @DoubleDingo post is spot on. Personally, I'd likely seriously consider doing a basic refresh on the 283 and swap in some form of...
-
RIn the mean time, you can adjust the clearance between the shift levers at the end of the column and it's very simple. There's a collar...
-
RNice find! I know LS is the big fad, but the small block is plenty reliable and can get good mileage when properly tuned. It being a...
-
RRicko1966 replied to the thread EFI Return Line Size.Oh yeah,and dropping a square tank is freaking easy. I was just stating that exhaust gas can be used as an inert gas when doing gas...
-
RIf you pull the drive shaft and start the engine and put it in drive, you run the risk of pumping all your ATF out on your floor...
-
RRicko1966 replied to the thread EFI Return Line Size.You don't even have to drain and fill with water, stick a garden hose in a tail pipe and in the tank with an engine running. The exhaust...
-
RRicko1966 replied to the thread EFI Return Line Size.I would assume excess fuel is being returned to the truck tank,not the surge tank, I very well could be wrong, I am making assumptions...
-
RRicko1966 replied to the thread New to the square body scene.Mt man Bob, you can buy bushings and rebush the throttle shafts,really not difficult if you buy the special piloted reamer,alternatively...
-
RRicko1966 replied to the thread EFI Return Line Size.I'm going to go out on a limb here,and say their tank is probably a reservoir. They are using your original pump to fill their...
-
RRicko1966 replied to the thread EFI Return Line Size.Boy I can't see why that wouldn't work either,the guys that designed that just must not know what they are doing. I'd suggest you just...
