Ricko1966's latest activity
-
RThanks! Ordered rebuild from national.
-
RAnd I would not recommend that NEW carburetor from National. I ordered one, it looks nice, but I sent it back as it is a giant chunk of...
-
RRead this: https://www.460ford.com/threads/timing-vacuum-advance-101-good-article-by-gm-engineer.117504/ Delco made a BUNCH of...
-
RRicko1966 replied to the thread hei vacuum advance stop plate.If you want to find MBT which I talked about in post 10. Set your total to 30* ,vac advance disconnected and plugged. Find two land...
-
RRicko1966 replied to the thread low oil pressure.Here's my thoughts. You need to call where ever you got it from and ask their advice abd suggestions. None of us can warranty it. My...
-
RRicko1966 replied to the thread Transfer case support brace. Who got one to sell?.Change the length of the bell crank arm.
-
RRicko1966 reacted to dragstews's post in the thread Transfer case support brace. Who got one to sell? with
Like.
I offered $100 and got a no in less than 5 seconds .. Even at that I was not wanting to pay that much .. So ... Going to get off my... -
RRicko1966 replied to the thread hei vacuum advance stop plate.After rereading this. I suggest you put it back together. As it was, old distributor. Make sure it runs right and as it use too before...
-
RRicko1966 replied to the thread hei vacuum advance stop plate.This is total timing "The centrifugal advance system in a distributor advances spark timing purely as a function of engine rpm...
-
RRicko1966 replied to the thread hei vacuum advance stop plate.If you read what Matt put up for you,you know how to set total. If not call accel ask them how much centrifugal the distributor has...
-
RRicko1966 replied to the thread hei vacuum advance stop plate.I've got some more time now exactly which accell hei are you installing? The plate is probably very neccesary. Most sbc depending on...
-
RI get it I have a few low psi fuel pumps. Thanks
-
RRicko1966 replied to the thread hei vacuum advance stop plate.You use the limit plate after you've figured your best total and curve. Those are figured before you add in vacuum advance. After you...
-
RRicko1966 replied to the thread Turbo 400 with rad cooler what lines are you using.Factory lines,to factory radiator internal cooler?
-
RRicko1966 replied to the thread 86 fuel filter.Something you don't need and I won't have soon.I am using it as a restrictor to regulate how much fuel I return. My factory pump is only...
