Recent content by Randy and Easton
-
New owner of an 87 K10 Stepside
Well howdy neighbor! We are NRH….. enjoy the build.. Randy and E- Randy and Easton
- Post #15
- Forum: Introduction
-
New to the squarebody family
Nice rig! Welcome from DFW- Randy and Easton
- Post #12
- Forum: Introduction
-
New owner of an 87 K10 Stepside
Welcome from DFW Texas!- Randy and Easton
- Post #12
- Forum: Introduction
-
Long Time Lurker, Finally Signed up 86' C10 SWB
Welcome from DFW Texas and have fun!!!! Thanks for the pic- Randy and Easton
- Post #11
- Forum: Introduction
-
New member from North Carolina
Welcome from DFW Texas. Nice motor- Randy and Easton
- Post #21
- Forum: Introduction
-
dash pad
…adequately titled my friend!!best of luck with that! Hahah- Randy and Easton
- Post #5
- Forum: Interior
-
Trash my dash? And interior panel take offs?
Lesson we learned in our build is you never throw anything away. Either you needed it later for a template, or someone else needed it or you can’t figure how the new stuff goes in and you have something to work with…..I can’t tell you how many times we needed something we had discarded months...- Randy and Easton
- Post #3
- Forum: Interior
-
Loose cab mount
We were very lucky on our cab mounts. We had read and saw some people on YouTube that had such trouble with them so we were prepared. We set aside an entire two days for just the mounts. Easton got the first one done in 20 minutes, and had them all finished before lunch the same day. We were...- Randy and Easton
- Post #6
- Forum: Exterior
-
-
Opinions on grounds needed
@RustyPile will be along shortly with some great advice but here is a great list. Randy and E- Randy and Easton
- Post #7
- Forum: Electrical & Audio
-
Alternator cable routing
That is awesome! Randy and E- Randy and Easton
- Post #10
- Forum: Tech Discussion
-
Belt squeal (while accelerating)/alternator question
We are with @Snoots and @Buck69 bigger belt. Here is a pic of E’s setup. Got belts on Amazon which has a Goodyear belt section with free shipping and returns. Due to our custom set up, we ordered several different sizes and sent back the ones we did not use. Very convienient Randy and E- Randy and Easton
- Post #10
- Forum: Tech Discussion
-
Remove accessories from this old truck?
We are a leave it!!- Randy and Easton
- Post #6
- Forum: Aftermarket Accessories
-
Easton Is Graduating Thank You all for your help GMSB!!
#grateful Randy and Easton- Randy and Easton
- Post #32
- Forum: Introduction
-
Vent window adjustment?
Lots of soapy water, or window cleaner and use a plastic tool to push it into the frame. The precision gasket came with a plastic tool that worked well. We found if you heated the gasket with heat gun or hot water (we did ours in December and it was cold in garage) they became more playable...- Randy and Easton
- Post #15
- Forum: Tech Discussion
