-
-
RRacer 238 replied to the thread Tire/wheel recommendations.Ended up adding a 1/4” spacer ring and was just enough to clear.
-
-
RYears ago I purchased them at Napa Auto Parts. Hopefully you have one nearby.
-
Rhttp://www.billavista.com/atv/pdf_index/files/Hardware%20and%20Fasteners/Dorman%20Wheel%20Studs%20and%20Nuts%20Catalog.pdf
-
RI’m looking for at least 1/2” longer thread (7/16-20) on the front studs of my 1978 k15. Has anyone had any luck tracking these down...
-
RRacer 238 replied to the thread Tire/wheel recommendations.That’s probably what I’m going with since I don’t need much. Looks like the thread length on the front axle studs is only .93”. Do you...
-
RI would just grind the tie rod end, just enough to clear. It won't take much.
-
RMr Gasket makes some thin ones. Just make sure your lugs are long enough.
-
RRacer 238 replied to the thread Tire/wheel recommendations.new wheels just touch the tie rod end. Otherwise clears the fenders just fine. Any recommendations on spacers?
-
-
RThere's two issues regarding turn signals. Different polarities and the flasher. Look for LED bulbs that say "non-polarity". These have...
-
RI've been told that a lot of the electronic flashers don't work correctly for all applications.-I'm not sure why it is hit or miss...
-
RI've got all LEDs in my '85 and they did the same thing, wouldn't flash at all even with the "LED flasher". I left the LED flasher in...
-
RYep front lights are wired funny on squares and you will have issues on front turn signals and markers because they won't always be...
-
RRacer 238 replied to the thread LED conversion.The rear LEDs only work correctly when the incadescents are in the front. I did not change over the hazard flasher to led but it acts...
-
RSorry late in the game here. The grey/silver truck was my '79 K15 that came with an old/stiff Rancho 4" lift. Back then it was wearing...
-
RDoing an LED conversion on my 1978 GMC k15. Have all the bulbs swapped out with the LED ground flasher. Cut the blue wire on front side...
-
-
-
Loading…
-
Loading…
