Old Guy Bill's latest activity
-
Old Guy Bill reacted to C10MixMaster's post in the thread What’s wrong with my axle tubes? with
Like.
driver side is stock ,passenger side has an axle saver bearing that locates the bearing to a clean part of the axle. -
Old Guy Bill reacted to Ricko1966's post in the thread How does this sort of thing happen???? with Like.
I got you a couple of pics.Ive had the argument too many times on here. I'm not going to get into the debate again. Putting the brace on...
-
Old Guy Bill reacted to fast 99's post in the thread How does this sort of thing happen???? with Like.
That's actually happened to me several times along with vehicles running out of gas either on road test or in the shop. It's very hard...
-
Old Guy Bill reacted to Ricko1966's post in the thread How does this sort of thing happen???? with Like.
Also if the battery or cables is questionable,the starter drive can get stuck. And with your turning and not turning etc. Check your...
-
Old Guy Bill reacted to Sad Sack's post in the thread How does this sort of thing happen???? with Like.
One thing to remember is GM heavy starters need that rear torque strap employed or the starter can get all wonky and tears teeth up on...
-
I’ve seen plenty of vehicles done with this. Usually, after a few years, it starts to chip and flake off. Not a fan, would rather deal...
-
Old Guy Bill reacted to Bextreme04's post in the thread Lost Two Gen 3 LS Engines in my 1986 C10 2WD with Like.
I'm just going to point out that 130psi on a 2002 5.3 is not OK compression. That should be 150-185psi AT LEAST. You need to verify...
-
It makes too much sense for people asking for help to give all the relevant information to make it easier for other members (members who...
-
Diagnose before changing parts. Your chances of getting a new good fuel pump is maybe 50/50. Check fuel pump pressure and volume. And...
-
I rotate the engine till the rod is in as far as possible, put some grease on the pump rod so that it doesn't slip out, double check and...
-
The short one won't hold it you remove the short one put in a long one,change the pump remove the long one,put the short one back.
-
They bend easier and more often than you think. At some point in its life someone probably changed the pump using a Long bolt through...
-
Old Guy Bill reacted to EvilGenius's post in the thread ‘83 K5 350/4wd: aftermarket oil psi switch/sender/choke heater wiring question w/pics and schematic with Like.
I think your understanding of that circuit is a little backwards. The reason the choke is wired with the oil pressure sensor is to...
-
I'd have a local builder build it and install it,that way if there's a problem,it's their problem,not your problem. I would not pay...
-
Old Guy Bill reacted to SquareRoot's post in the thread Modified engine crewcab gas mileage? with Like.
New guy asking about fuel milage... :laughing1: 10....like everybody else.
