Nasty-LSX's latest activity
-
-
Nasty-LSX replied to the thread Transfer case support brace. Who got one to sell?.SENT!! :happy160: Thanks again (OriginalThor)
-
-
Nasty-LSX replied to the thread Performance 700r4 rebuild.BIG TIME MONEY!!!! At least you know its gonna hold. :happy160:
-
-
Big money Sonnax input drum and input shaft. Borg Warner frictions, lindered 3/4 steels, plain steels in overrun and forward clutch...
-
New OEM reverse input drum, new frictions and steels. New Borg Warner low roller clutch, and Sonnax smart shell race. Sonnax wide sun...
-
-
@Wumbo - For some reason this website isn't letting me quote but the round hole rev input drums are obsolete so yea, was def a cost...
-
Nasty-LSX replied to the thread P/S pump pressure side fitting size on 97/07. Want to convert to AN fitting (pic's).Im guessing this would be it!
-
-
Nasty-LSX posted the thread P/S pump pressure side fitting size on 97/07. Want to convert to AN fitting (pic's) in Tech Discussion.I am updating the stepside LS FEAD. Removing the holley and putting a billet drive. I got a P/S cooler for this setup and need a AN...
-
-
Trivia; the first couple of years of K30’s used the short 2wd style hangers with blocks.
-
4wd hangers drop down farther which lifts the frame & negates the use of a lift block. I figured this out when I was a young pup. I've...
-
Yeah, I’ve seen it done with 2 and 4wd hangers (I doubt most folks realize there’s a difference).
-
Isn't the old trick for a flip is to use the front 2wd hanger in place of the rear 4wd & then flipping the swing? HS
-
My bet is that’s a typical 4” kit without the shackle flip. The flip brackets look well built but homemade, I haven’t seen any built...
-
So browsing the kijiji coffee and some one posted of this for 200 bucks. I said I'd be there for how ever it takes me to get to his...
