mxer147's latest activity
-
mxer147 reacted to Texan Cris's post in the thread I just won a 1985 1 ton C/K Four door from the auction. going to pick it up next week ill post pics. Are there any four door square body guys on here? with
Like.
Here is one that I plan on sending to Mecum Dallas. -
mxer147 reacted to Fubar500hp's post in the thread I just won a 1985 1 ton C/K Four door from the auction. going to pick it up next week ill post pics. Are there any four door square body guys on here? with Like.
Welcome from TN
-
mxer147 reacted to Rome03's post in the thread What have you done to your square lately?? with Like.
Cigarette lighter wasn’t working. Ordered a usb charger to replace it. Had to cut the hole a bit for the larger body, but I can charge a...
-
mxer147 reacted to aasleson's post in the thread What have you done to your square lately?? with Like.
Finally found a set of 31x10.5x15's and even came with a decent set of rims, we'll see how the paint holds up but they were $600 and the...
-
I would think thats a whole lot more $ than spraying it single stage. I'm doing base-clear.....was told 1.5 gal (3 gallons...
-
mxer147 replied to the thread How much paint do I need?.I’d consider a camouflaged paint job, look good as well, hides imperfections and reasonable cost.
-
mxer147 replied to the thread How much paint do I need?.That’s what I did, summit single stage paints, white and orange, purchased 2 gallons orange, one gallon white, plus reducer, and...
-
I'd spray it,even with a cheapo gun. It's still going to be less$ and a better outcome than 900 spray cans. But honestly I'd pony up for...
-
mxer147 reacted to Bloodhound1981's post in the thread What have you done to your square lately?? with Like.
I installed this hood pad I got from Detroit Muscle Technologies...
-
mxer147 reacted to Terlingueno's post in the thread What have you done to your square lately?? with Like.
Since I now desire the metering rods to activate a little bit earlier on my carb, yesterday I removed the 'orange' 5" step up springs...
-
mxer147 reacted to Camar068's post in the thread What have you done to your square lately?? with Like.
Replaced bumper. Stripped paint with citristrip, then 10 coats of VHT epoxy. Cleaned stainless bolts and put new antiseize on them...
-
mxer147 replied to the thread Paint on Emblems - removal.Citristrip will remove ALL the paint. Liberally brush it on, place in sealed plastic bag, wash in 24 hours. Repeat, if needed. You will...
-
mxer147 reacted to PrairieDrifter's post in the thread What new tools have you got lately? with Like.
It's a 67-72 coil spring setup. Come on ricko!! It's already got coil spring spacers :rofl: It's definitely not the choice I would do...
-
Got me a new/used 2lb, Made in Detroit, brass hammer
-
Going off memory... All taillight screws are #8 sheet metal screws. The ones in the housing are phillips head. The ones for the lens...
