mxer147's latest activity
-
mxer147 reacted to Mr Clean's post in the thread Scores from DIY Parts Yards, Pull A Part, U Pull It etc with
Like.
Went to a auto Swap Meet today. Found a few goodies. Seats for the Mistress, Hi Lift jack for the Extracab. Small cap HEI distributor... -
mxer147 reacted to bucket's post in the thread Scores from DIY Parts Yards, Pull A Part, U Pull It etc with Like.
Not from the junkyard, but close enough. Today I picked up these old lightweight plastic race seats that were put out for free at the...
-
Picked up a "broken" 3D printer for $30. Needed a new cable. Got a whole cable kit for less than $15 shipped. Slapped the laser engraver...
-
mxer147 replied to the thread What have you done to your square lately??.Rust oleum hood underside and some associated parts. Used some enamel hardener this time.
-
-
Holes drilled Hung it back, lifted the whole thing enough to remove the steer wheels so I could throw the bolts through and tighten...
-
Drove it. Filled it up and drove to nearby town, about 1/2 a tank away (15 miles). Just kiddin of course. Beautiful day for a drive.
-
mxer147 reacted to Tank6x2's post in the thread What have you done to your square lately?? with Like.
Spent the last couple of weekends Attempting to stay focused on just the firewall- cutting it apart, fabricating the brake support...
-
If you need the best scale plates made, see my buddies page. https://www.rcplateshop.com/
-
New Toro Z Master 60"
-
I filled all the speaker holes (and cracks) with fiberglass/bondo and wrapped in leather. btw I like the seam to just be around the...
-
Did the shifter too, I need to shoot another one to do some on the door panels
-
mxer147 reacted to bucket's post in the thread What have you done to your square lately?? with Like.
That's a bada$$ truck right there!
-
mxer147 reacted to legopnuematic's post in the thread What new tools have you got lately? with Like.
I forgot to attach a picture of said test piece, just so y'all's know it really was a test piece... Grabbed ferrule kit and back probe...
-
Yes, to use up the old bodies and chassis. GM did the same thing with the 400/OBS series, when the 800/NBS truck debuted in 99. 1999...
-
mxer147 reacted to SirRobyn0's post in the thread What have you done to your square lately?? with Like.
Well today was the day. I took the truck to the shop, and I was off today so I spent the entirety of the day working on the truck...
