mtbadbob's latest activity
-
The former owner did an on frame restoration a few years back. Time to see how much additional work is needed. My guess is more than I... -
I added this little guy two years ago. Wiring wasn’t a major pain and it is still working just fine. Since it triggers the locks by...
-
Back in the day, about forty or so years ago, when my 69 step side was my other baby, I installed capacitive discharge to solve the...
-
Even Gen III LS engines with 8 coils had a TSB to drop the plug gap to reduce chugging and hesitation and driveability issues in the...
-
IIRC, .060 plug gap was an early spec for HEI, maybe when they were trying to improve the burn for emissions. Later on they found it...
-
Computer heat sink paste. So,your local computer shop
-
When HEI first came out, the modules did have some reliability issues. It didn’t take long for Delco to figure it out and solve the...
-
If you are not using a GM module in your HEI distributor then there is a good possibility your dwell time is not correct thru the entire...
-
I have a cheap china HEI distributor in mine, but when the module went out I replaced it with an AC Delco module and it has been working...
-
Basically same as valve float. Inability to control opening and closing. Solving point float sounds easy, increase closing spring...
-
Many times I've told people on here that to the best of my knowledge only GM and NAPA premium ignition modules vary dwell. Some of you...
-
mtbadbob reacted to Matt69olds's post in the thread Need help with my freshly rebuilt carb with
Like.
It’s been 30 years since I messed with setting the mixture control solenoid on those carbs. If I remember correctly, there is a green... -
Totally GAY
-
Someone spent an incredible amount of time and material on that. Too bad they won't recover what the paint cost. Question where people...
-
Looks like a pride flag with wheels.
