Mr Clean's latest activity
-
We do the same with hammer and pry bars, but use an air hammer for the stubborn ones. -
Just picked up a pickle fork this weekend from HF so I could finish my drag link up and get the truck back on the road. While I was...
-
Mr Clean reacted to legopnuematic's post in the thread What new tools have you got lately? with
Like.
I have a FSI riv nut gun. Military surplus, they were on ebay for pretty cheap some years back. -
This is by far my most favorite tool for installing RivNuts...
-
Mr Clean replied to the thread What new tools have you got lately?.I have the big one like you just got for my steel Riv Nuts, I have a small hand one like a pop rivet for my aluminum Riv Nuts. They are...
-
Got this RivNut tool today. My Ford buddy had bought bedside cleats for his truck with the cheesiest POS hardware for installing the...
-
Mr Clean replied to the thread New Square Jimmy owner, starts with the floors.:welcome:
-
Mr Clean reacted to Jawzjeep's post in the thread New Square Jimmy owner, starts with the floors with Like.
Sounds like lots of fun. My K5 was similar and that the floor was so rusted out the seats were falling in and it had no rockers. Lots of...
-
Mr Clean replied to the thread New to the party..:welcome:
-
When I had the front end off to change the inner fender wrlls. I also did a complete detail of the engine bay. NOTE this is when you...
-
A few pictures of the interior
-
Hi everyone. Just joined up. I've had my bronze colored C10 for about 6 years done lots of work to it. New interior, changed the inner...
