Recent content by Maxgforce

  1. Maxgforce

    Speed nuts?

    https://www.americanclassic.com/mobile/1981-91-Dash-Panel-Molding-Billet-Aluminum-w_AC/productinfo/32-069A/
  2. Maxgforce

    Stripped intake manifold bolt help

    If it's the very back bolt, helicoil is easy because the hole bottoms out. If it's any of the middle 8 bolts (4 on either side), the threaded hole is bottomless. Helicoil will still work but need to use red threatlock, to prevent the helicoil from unscrewing as you tighten the bolt, (hope that...
  3. Maxgforce

    1974 Chevrolet C10 Stepside Build....

    What color are you going with?...and can't help noticing how big your shop is :happy107:
  4. Maxgforce

    Engine oil

    Guess everyone is entitled to having a bad week every now and then, and that's where I'm at. I may have misinterpreted some of the comments, so I do apologize. But it wasn't 15w40 that I was concerned about, rotella came out with a gas truck engine oil......why would that need to be different...
  5. Maxgforce

    Engine oil

    Oh so high and mighty are we?, being a senior member in a forum. Go on and continue to be proud of that pathetic calling. Oh and by the way, I wasn't talking about 15w40......so apparently your falling behind with regards to new products. So sit back with your crown and continue to be smug to...
  6. Maxgforce

    Engine oil

    Here's a question, just seen a Rotella commercial for truck oil?? And the commercial was pushing the fact that you don't run car oil in your truck. I think it's a load of crap but maybe I'm missing something? But since the vette runs a 6.2 and lord behold so does the denali....I think it's total...
  7. Maxgforce

    C10 5/7” drop

    A 215/70r15 is 26.7 tall.....would match your rear tires as far as height...but would need a 15x7 rim
  8. Maxgforce

    C10 5/7” drop

  9. Maxgforce

    C10 5/7” drop

    Sorry, didn't mean to post the first one twice. But your front tires are 28.1 tall and the rear are 26.8......is that ok?
  10. Maxgforce

    C10 5/7” drop

  11. Maxgforce

    C10 5/7” drop

  12. Maxgforce

    Poor mpg

    If you look in any repair manual, .35 gap is for 250 CID and anything that is running breaker points. With an HEI it reccomends .45, but after building dozens of engines and running them in Moab and the drag strip I've found out that .40 with an HEI works the best. I run autolite 24 at the...
  13. Maxgforce

    Break-in oil

  14. Maxgforce

    Dual gas tank issue

    What year? 70's had a different tank switch than the 80's.
  15. Maxgforce

    How can you tell if an off-idle stumble is caused by a lean or a rich condition? Carb

    That is correct ☝️
See more

Latest posts

Forum statistics

Threads
42,315
Posts
913,554
Members
33,812
Latest member
millernf
Top