I'm currently installing a 47re trans in my project. I have compiled pin outs and pic diagrams and what I've done so far. Was waiting till I got it running to make sure I had everything right, but I can give you what I know so far
Thanks! Put some more work in today since my football team sucked lol
And that's just primer and rattle can! This isn't the exact color, but close enough for right now
Check out 4btswaps.com
They have a section just for tranny swaps to our Cummins. But there aren't many options for less than $1600. If you are set on a manual, the nv4500 is the best ticket.
Do you have a rh or re trans now? Those can be built bad ass for around the same money you would spend...
Frame body dropped, engine mounts in place and most all the fab work done and painted
Trans tunnel raised and covered back up
[URL=http://s190.photobucket.com/user/dajizzsocal/media/Cliffor[/URL]
Since I work for a equipment rental company, I have some perks of the job haha
Here is my air compressor off an F700 school bus. It will fit without trimming if one was not doing a bodydrop
There is room to use the factory location engine mounts, but they would have to be custom mounts...
This is the passenger "mid mount" modeled after the bell housing mounts found on the class 8 trucks. Left side of the pic is the trans bell housing bolts sandwiching the new mounts to the frame on the right of the pic. Same thing on the drivers side
This is the removable trans mount using...
Hey guys! New here to this forum, thought I'd share my project with you.
Its an 82 crew cab camper special 2wd. I'm bagging and body dropping at the same time as the engine swap.
I'm installing a 95 p-pump 12v along with a already built 47re trans from the donor truck. I thought I'd make it...