Search results
-
L
Cummins Coversion wiring/computer questions
I'm currently installing a 47re trans in my project. I have compiled pin outs and pic diagrams and what I've done so far. Was waiting till I got it running to make sure I had everything right, but I can give you what I know so far- lowcharacter
- Post #6
- Forum: Diesel 6.2, Conversions Cummins, etc.
-
L
12v Cummins swap
Nope, haven't been over there- lowcharacter
- Post #8
- Forum: Diesel 6.2, Conversions Cummins, etc.
-
L
12v Cummins swap
Thanks! Put some more work in today since my football team sucked lol And that's just primer and rattle can! This isn't the exact color, but close enough for right now- lowcharacter
- Post #6
- Forum: Diesel 6.2, Conversions Cummins, etc.
-
L
12v cummins tranny options
Rh is the hydraulically controlled (no power train computer module) Re is the electrically controlled (has more harness plugs in it)- lowcharacter
- Post #4
- Forum: Diesel 6.2, Conversions Cummins, etc.
-
L
12v cummins tranny options
Check out 4btswaps.com They have a section just for tranny swaps to our Cummins. But there aren't many options for less than $1600. If you are set on a manual, the nv4500 is the best ticket. Do you have a rh or re trans now? Those can be built bad ass for around the same money you would spend...- lowcharacter
- Post #2
- Forum: Diesel 6.2, Conversions Cummins, etc.
-
L
12v Cummins swap
Frame body dropped, engine mounts in place and most all the fab work done and painted Trans tunnel raised and covered back up [URL=http://s190.photobucket.com/user/dajizzsocal/media/Cliffor[/URL]- lowcharacter
- Post #4
- Forum: Diesel 6.2, Conversions Cummins, etc.
-
L
12v Cummins swap
Since I work for a equipment rental company, I have some perks of the job haha Here is my air compressor off an F700 school bus. It will fit without trimming if one was not doing a bodydrop There is room to use the factory location engine mounts, but they would have to be custom mounts...- lowcharacter
- Post #3
- Forum: Diesel 6.2, Conversions Cummins, etc.
-
L
12v Cummins swap
This is the passenger "mid mount" modeled after the bell housing mounts found on the class 8 trucks. Left side of the pic is the trans bell housing bolts sandwiching the new mounts to the frame on the right of the pic. Same thing on the drivers side This is the removable trans mount using...- lowcharacter
- Post #2
- Forum: Diesel 6.2, Conversions Cummins, etc.
-
L
12v Cummins swap
Hey guys! New here to this forum, thought I'd share my project with you. Its an 82 crew cab camper special 2wd. I'm bagging and body dropping at the same time as the engine swap. I'm installing a 95 p-pump 12v along with a already built 47re trans from the donor truck. I thought I'd make it...- lowcharacter
- Thread
- Replies: 11
- Forum: Diesel 6.2, Conversions Cummins, etc.
