KSSB's latest activity
-
KTwo remotes, a wall unit inside the shop and an exterior unit that takes a pass code.
-
KI guess I just don't understand then. I've pulled the same loads I described earlier with dually trucks and also C4500's. It's not much...
-
KI think the WD hitch benefits are more pronounced with higher profile loads that act like a sail. I think I can feel my small bumper...
-
KUnfortunately dad's old C20 Crew with almost 50 years of fighting gravity & 400K miles isn't gonna be hauling much until I can address...
-
KRides better with a load that's loaded or hauled right. Springs & truck do very good from the General. There's no way I'd attempt this...
-
KIn fact, this set up crossed the Rockies when we moved from Michigan to Arizona - K
-
KMine was a daily for 30 years and 200000 miles. Light hauling, trailering, and back and forth to work. It's what they were made for...
-
KMy ol' girl has to earn her keep!
-
KHere's my '16 2500HD Max with a 10K 34' tag-along, dismantled '32 deck & 50 pavers & whatever junk would fit in the bed. This is WITH a...
-
KHere's my...my dad's C20 Crew pulling a 28' camper in the early 80's. He didn't kill it but from memory it pulled fine. 350/SM465 &...
-
KWhat is your intended use for the booth? A booth won’t necessarily make or break a paint job, lots of very good work has been done...
-
KThese are for the standard rear fleet side bumper. Was on a C30.
-
KThese are what ive always called parrot jaw. Apparently they are also in the same catagory as pictured earlier.
-
K87Scotty -- Man, I'm diggin' those terminal cleaners! Probably should use some kind of lubricant on the cleaned connector pins to...
-
Kbought a Milwaukee 18v fuel cordless grinder. invaluable. its great to move it around and get into tighter spots without having a cord...
