-
-
KGetting to the stage in my project where I need to remove the cab from frame and get it on a rotisserie, which is the style that would...
-
KLooking for the rod/link that goes from the cruise control vacuum servo to quadrajet, for mid 80s 350 sbc, appears to need to be around...
-
-
KHello, just wondering if there are any noticeable differences between power steering pumps used on a 1987 3/4 ton 4x4 (350 V8) compared...
-
KKilian replied to the thread AC Conversion Questions.Thanks. I did find the Ester oil recommendation when searching this site and will be using that. I'm resealing the A6 compressor and...
-
KKilian replied to the thread AC Conversion Questions.Where is that TSB available from?
-
KKilian replied to the thread AC Conversion Questions.Is there any benefit in using an auto adjusting orifice tube? I see those are available as well but don't know enough about them. Thanks!
-
KHey folks, converting the old R12 system to R134a and I've searched a lot on this site and had some of my questions answered, but have...
-
KKilian replied to the thread What is this??.Is the TRC system not used if the truck is equipped with AC? I think the AC solenoid for increasing idle speed when the AC is on is...
-
KKilian posted the thread TRC Actuator and Air Conditioning Solenoid Question in Engine & Performance.I have a 1983 3/4 ton with 350 V8 and heavy duty emissions that has the throttle return control (TRC) system with a vacuum actuator at...
-
KMerry Christmas everyone! Anyone installed a Heartthrob manifold back dual exhaust on a 4WD truck with the wavy-style crossmember? I...
-
KKilian posted the thread Saginaw Steering Gear Rebuild - Special Tools? in Suspension, Steering & Brakes.Forgive me if I'm beating a dead horse but couldn't seem to find similar threads...I'm preparing to rebuild a steering gear from an 87...
-
KKilian replied to the thread 81-83 vs 84-87 Cab Mount Question.Are they rubber or poly? I'm looking at the site and don't see it listed.
-
KI was looking on the LMC Truck website for cab mounts and saw that they have different rear cab mounts for 81-83 and 84-87 trucks. I'm...
-
KIs there a grease seal or cap that's used on the 4WD front driveshaft to keep dirt out of the spline area where the two parts fit...
-
-
Loading…
-
Loading…
