Recent content by K5Rob

  1. K

    Floor and rocker options

    Wdym by “front edge”? Are there bolts in the wheel wells? Also are there bolts on the step-up just behind the front seats? Do you have any pics of this by chance?
  2. K

    Leaky K5 tailgate

    Thanks bucket I saw the seal and that is what I was wondering. If it still leaks I will replace the seal
  3. K

    Leaky K5 tailgate

    Hey guys I have been working on my K5 power glass tailgate. Replaced the rotted sash, got the window all the way up now. Replaced the shot outer window sweep and it still leaks water into the interior. The sweep is seated nicely. I have the inside tailgate access panel removed and I found that...
  4. K

    4L60E transmission cooler

    Has anyone plumed a transmission cooler using AN fittings and if so do you know the thread size for the GM coolers that came with the quick connect clip fittings?
  5. K

    AN fuel line kits

    Thanks guys
  6. K

    AN fuel line kits

    Hey guys got my LS set in my K5, I think I’d like to go with the AN fuel line kits found on ebay and the like. I will need a kit for fuel and also transmission lines. This will be my first time working with AN fittings. Does anyone know what size line is appropriate for a mostly stock 5.3? Also...
  7. K

    Bell housing / transfer case bolts

    Thanks for the pic. Do you think they are necessary or are people leaving them out when doing ls swaps Does anyone know if the 4x4 trucks of ~ 99-07 had these stiffener bars? My 2wd did not
  8. K

    Bell housing / transfer case bolts

    My LS and 4L60E came from a 2wd and I dont remember bolts at the bottom of the bellhousing but wear marks indicate that there were bolts there
  9. K

    Bell housing / transfer case bolts

    Hey guys just got the LS dropped in my 87 K5 along with the 4L60E and the original to the truck np208. Need the following bolt sizes has somehow I misplaced them. - 2 bottom bellhousing bolts near oil pan (see pic) - transmission mount stud nuts (mount to crossmember) there are 2 of them -...
  10. K

    87 TBI firewall fuel relay

    Does someone have a pinout for this relay, or know which wires go where. Doing an LS swap and i know the LS pcm will supply +12v signal for the relay. I would like to use the existing square body relay and TBI fuel system and just replace the pump in the sending unit with one from a ~97 3500...
  11. K

    Rear glass sash rubber

    Well i installed the glass into the sash using the rubber and urethane. First I test fit dry using the rubber and the sash basically slipped right on, not very tight at all. I then laid a bead of urethane in the sash, got the rubber just started in the sash, then a bead of urethane in that, and...
  12. K

    K5 rear window sash orientation

    Like this?
  13. K

    K5 rear window sash orientation

    Hey guys my rear window sash was completely gone so i have a new one in hand but not sure which way its oriented. There are two angles on it and some u cannel type things on the end. Which way does it go?
  14. K

    Rear glass sash rubber

    Thanks. Do you think the RTV is helpful or just go with the rubber? I do have RTV on hand but not urethane and I know its expensive.
  15. K

    LS regasket question

    So i got around to doing the covers and the oil pan. The pan was the most finnicky for some reason. I put a healthy glob of rtv in the corners, checked, rechecked and torqued down. Then checked again, and somehow it had moved just out of spec. So i had to back off the bolts and readjust to my...
See more

Latest posts

Forum statistics

Threads
45,947
Posts
996,623
Members
39,141
Latest member
jbwhitford
Top