Jrgunn5150's latest activity
-
Jrgunn5150 reacted to aasleson's post in the thread What have you done to your square lately?? with
Like.
Got tail lights, bumper and bed pulled off the CUCV and got the service bed pulled around to start taking measurements for making the... -
Jrgunn5150 reacted to idahovette's post in the thread What have you done to your square lately?? with Love.
Done NOTHING to my square. Just got the word that Gary is done with the paint, gotta go pick it up a 11AM TODAY!!! I will post pics when...
-
It's just a reinforcement plate. That inner bolt goes to the firewall.
-
Should be for the electric choke. That way the choke is only supplied power when the engine is running and producing oil pressure.
-
Jrgunn5150 reacted to Camar068's post in the thread What have you done to your square lately?? with Like.
Replaced bumper. Stripped paint with citristrip, then 10 coats of VHT epoxy. Cleaned stainless bolts and put new antiseize on them...
-
Jrgunn5150 replied to the thread What have you done to your square lately??.I do a lot of engineering filaments, PPS, PA6, PA12. Not too many "prosumer" printers that will run them out of the box, it does very...
-
-
Citristrip will remove ALL the paint. Liberally brush it on, place in sealed plastic bag, wash in 24 hours. Repeat, if needed. You will...
-
Jrgunn5150 replied to the thread What have you done to your square lately??.You can just break files into pieces. I have 2 Bambu P1S printers and a Bambu H2D, but nothing fancy is required for this. For this...
-
Jrgunn5150 replied to the thread What have you done to your square lately??.This is actually for my 4runner, but I'm pretty close to having a mock up LS block printed.
-
-
Jrgunn5150 reacted to straydog371's post in the thread What have you done to your square lately?? with Like.
Power steering pump had been squealing a bit (belt was tight and fluid level was fine) and finally developed a major leak. Pretty sure...
