Recent content by jrfonte
-
J
1UZ-FE, Flamesuit donned
If your planning on going with a toyota engine why not the 5.7 v8 they have in there tundras twice the hp and and torque of the one your looking at.- jrfonte
- Post #9
- Forum: Engine Swaps (Gas) LS, Vortec, LT1 , etc.
-
J
v belt to serpentine conversion
Thanks. now just to pull it off and pull the engine out go through it and trans. Blast frame and fire wall paint and put back together.- jrfonte
- Post #8
- Forum: Engine Swaps (Gas) LS, Vortec, LT1 , etc.
-
J
v belt to serpentine conversion
Got everything on checking fit n finish all I need now is for my waterpump pulley to come in.- jrfonte
- Post #6
- Forum: Engine Swaps (Gas) LS, Vortec, LT1 , etc.
-
J
v belt to serpentine conversion
Yea its a piece together lol. The smooth pulley is what I pulled off the old water pump. I found the part number fr the serpentine pulley to fit the new pump its an a/c delco #10085760 and here is a link to one. The old pulleys bolt pattern is to large for the new pump...- jrfonte
- Post #4
- Forum: Engine Swaps (Gas) LS, Vortec, LT1 , etc.
-
J
v belt to serpentine conversion
Well I pulled the cover off the new pump just to see the direction of the impeller and its the same as the serpentine pump. So I guess my only question is now is what pulley do I need to fit it?- jrfonte
- Post #2
- Forum: Engine Swaps (Gas) LS, Vortec, LT1 , etc.
-
J
My v-belt to serpentine belt conversion
to the op do you have a part number for the water pump and pulley for the serpentine swap?- jrfonte
- Post #47
- Forum: Engine & Performance
-
J
v belt to serpentine conversion
I have an 83 c10 with a 96-00 350 vortec engine (10243880) has the 83 v belt drive on it. I bought a serpentine setup from a buddy off what he said was a 94 5.7 to install on this engine. I got all the brackets, alternator, old water pump and he gave me a new water pump with it and a/c delete...- jrfonte
- Thread
- Replies: 7
- Forum: Engine Swaps (Gas) LS, Vortec, LT1 , etc.
