Ok! May have corrected the issue! I repaired a ground from the frame to the bed. This seems to have remedied the brake light issue. As far as the turn signals. I used a Power Probe to test the wires going to the switch in the column and from the connector, through the bulkhead and too the tail...
1. I’ve got the brake lights back working. I repaired a broken ground between the frame and the bed, just behind the cab and replaced the brake light switch.
2. I have not replaced the flasher but I did swap the two, one for the hazard and one for the turn signals. Nothing changed there.
3...
Thanks Donald. All of this started just out of the blue! Ran a short errand in the truck and when I got back home my wife noticed the brake lights not working. The bulbs were the same ones that were in the truck before. The bulbs test good and both filaments are intact.
I have since got the...
Thanks Donald. Bulbs are all good. This problem started out of the blue. Everything thing was working fine. I ran an errand in the truck and was gone about 15 minutes. When I got home, my wife noticed the the brake lights weren’t working. I have since got the brake lights back but still haven’t...
I am looking for ideas on solving issues with me brake and turn signal lights. My 78 C10 has no brake lights and when you turn on turn signals the front lamps work as they should. But, both rear lights “blink” with either the right or left side selection.
I have changed the turn signal switch...