hack_man's latest activity
-
Hhack_man replied to the thread Update on my Ignition Module failure!.So what's the safest way to disable ignition if you want to crank the engine without it starting? Pull the electrical connector plug on...
-
Hhack_man reacted to Rebuildman's post in the thread Update on my Ignition Module failure! with
Like.
The module will also fail if it gets too hot. It is mounted to a heat sink that needs the proper paste applied on the mating surfaces so... -
Hhack_man replied to the thread Gas in Oil!?.Mine was something like this gas filter, just not the exact same PN Yes metal generic can with simple barb on each end The problem with...
-
Hhack_man replied to the thread Gas in Oil!?.I also learned the hard way never use plastic fuel filters, always get the metal can. I drove my truck to the garage for its yearly...
-
HMy fuel pump was leaking oil like crazy out of the weep hole. Any time I'd load up the engine over 2500 rpm, it would spew oil all over...
-
Hhack_man replied to the thread Gas in Oil!?.I have the same problem having to crank and crank a long time after it's been sitting for a week. I've found if I set the choke with a...
-
HYes,steeper gears are weaker,but at the power levels we are dealing with I don't know that it's a problem.
-
Hhack_man replied to the thread What gears.Do the higher ratio gears cause either the ring or pinion gears to get weaker because the teeth are smaller since there's more of them?
-
Hhack_man replied to the thread Proportioning Valve and Bleeding.Cracking the bleeder so the fluid doesn't get pushed back into the m/c has the added benefit of keeping the bleeder unfrozen during...
-
HI drain the master cylinder before I do a brake job with a turkey baster or a Mighty Vac, clean it out as best as possible and refill...
-
Hhack_man replied to the thread Proportioning Valve and Bleeding.I got mine from a local GMC dealer in 2006 "just in case" the old one had a problem. Looks like this part is still available at not...
-
-
HWhere did you get your proportioning valve and what was the part number????
