Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
Registered members
Current visitors
Menu
Log in
Register
Install the app
Install
Members
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
gmbellew's latest activity
G
gmbellew
replied to the thread
rear tailgate power window motor Blazer/suburban
.
Next time I have a window failure of some sort, I plan to use them also. I might even just jump to the 4 windows plus the tailgate...
May 13, 2025
G
gmbellew
replied to the thread
rear tailgate power window motor Blazer/suburban
.
https://www.nu-relics.com/category-s/558.htm
May 13, 2025
G
gmbellew
reacted to
Ricko1966's post
in the thread
Engine woes
with
Like
.
TBI is weird you really need to follow the factory diagnostics,because ECM ,and ignition module both control the ignition but at...
May 7, 2025
G
gmbellew
replied to the thread
Source for rear AC fittings?
.
that's correct
May 7, 2025
G
gmbellew
replied to the thread
Replacing the TBI engine, suggested upgrades or changes?
.
grab the PROM from the 5.7. you will need it. I also assume you are using the TBI from the 350 with the 350 injectors? I think 305 and...
Apr 27, 2025
G
gmbellew
replied to the thread
1990 TBI misfire/popping exhaust
.
yeah, inspecting the cap excess carbon is a good idea. and I agree on not skimping on ignition components!
Apr 24, 2025
G
gmbellew
replied to the thread
1990 TBI misfire/popping exhaust
.
might double check to make sure you have the firing order correct.
Apr 24, 2025
G
gmbellew
replied to the thread
1990 TBI misfire/popping exhaust
.
EGR is closed at idle. so unplugging the vac to EGR doesn't do anything at idle. manually opening the EGR, or using a mityvac to open...
Apr 24, 2025
G
gmbellew
replied to the thread
Show your daily driver
.
also a lot more interior space compared to a 2 door
Apr 20, 2025
G
gmbellew
reacted to
Ricko1966's post
in the thread
O2 Sensor
with
Like
.
This thread is old and dead. Rather than trying to use pots or other resistors,the correct plan would be run the correct injectors,for...
Apr 11, 2025
G
gmbellew
replied to the thread
O2 Sensor
.
uh- I did read it. this is what you wrote - "It doesnt take much heat to operate the O2S, they all should have internal heaters. Is...
Apr 11, 2025
G
gmbellew
replied to the thread
O2 Sensor
.
Single wire O2 has no heater and relies on exhaust to heat it up.
Apr 11, 2025
G
gmbellew
replied to the thread
LED exterior light conversion! not going well :(
.
I just used LED on headlights and auxillary fog lights where it really matters and kept the rest incandescent. I have seen too many...
Apr 11, 2025
G
gmbellew
replied to the thread
What have you done to your square lately??
.
that's all it does to attach. move the throttle to WOT with your hand and see if the cable appears tight
Apr 8, 2025
G
gmbellew
replied to the thread
What have you done to your square lately??
.
just move the throttle all the way to WOT at the tbi. if the cable is tight like a guitar string, you should be fine. it may click a...
Apr 8, 2025
Latest posts
Intake manifold and stripped bolt
Latest: 75gmck25
15 minutes ago
Tech Discussion
New Super Square…
Latest: 1984K30
Today at 3:34 AM
Garage
85 vent windows
Latest: BadBowtie
Today at 2:47 AM
Glass & Mirrors
Think I found a somewhat rare truck
Latest: BadBowtie
Today at 2:33 AM
Introduction
Steering Wheel Too Close '84 C-10
Latest: BadBowtie
Today at 2:28 AM
Interior
Forum statistics
Threads
45,947
Posts
996,624
Members
39,141
Latest member
jbwhitford
Members
Top