fast 99's latest activity
-
fast 99 reacted to Matt69olds's post in the thread Need help with my freshly rebuilt carb with
Like.
It’s been 30 years since I messed with setting the mixture control solenoid on those carbs. If I remember correctly, there is a green... -
fast 99 reacted to 77Dmax's post in the thread 5.7 back fires through carb but timing is good. with Like.
I would check for a flat cam. Turn it over with the valve covers off and have a look.
-
fast 99 replied to the thread rough idle.Engine running dribble fuel into the front venturies one side at a time. If one picks up and smooths out that side idle circuit is...
-
fast 99 replied to the thread 5.7 back fires through carb but timing is good..40% is high but that alone isn't enough to condemn the engine. Old cold [when tested] engines can read high and be good runners. Was it...
-
fast 99 replied to the thread High oil pressure after replacing pump.Or a SB Ford that twists distributor drive shafts and or destroys drive gear. Just went through that a couple months ago on my own car.
-
fast 99 replied to the thread High oil pressure after replacing pump.That's a slight bit higher than most SB I have seen but not high enough to worry about. After all, it's not a Chrysler that blows oil...
-
fast 99 replied to the thread 5.7 back fires through carb but timing is good..Generally speaking backfire into intake is lean from whatever cause: carb, vacuum leak, ignition misfire. almost any valve a train...
-
fast 99 reacted to legopnuematic's post in the thread Bolt hole pattern on the front of the heads with Like.
All small block heads with accessory holes should be the same pattern, late 60s to vortec era. The 1986 and older is likely from being...
-
fast 99 replied to the thread Leaking power steering fluid from Hydra boost unit..I used a local rebuilder for HB units. However, ones that had a staked push rod on the brake pedal side could not be rebuilt. Apparently...
-
fast 99 replied to the thread 55-75 OE distributor.Both materials, have seen cast iron more on late 50's vehicles. Some Corvettes used iron later into the 60's that included a tach drive.
-
fast 99 replied to the thread Power steering gear box.Inspect for worn front suspension parts. Possible shifting side to side.
-
fast 99 replied to the thread Hate it or Love it, it's sweet.Someone spent an incredible amount of time and material on that. Too bad they won't recover what the paint cost. Question where people...
-
check this out. Gotta admire the dedication to the project! 1994 ranger, could be yours for $8000 :banana-mario...
-
fast 99 replied to the thread Brake Booster Adjustment.Could the swinging pedal shaft be worn or tight?
-
fast 99 replied to the thread Engine oil lines..I believe you will find a small horizontal clip. If one is there, pull it out fitting will come off. Hard to say what is actually...
