Edelbrock's latest activity
-
Edelbrock replied to the thread What have you done to your square lately??.There have been 4,668 days since July 11, 2012. That's when this topic started. So if your kid was born at that time, he/she would... -
Edelbrock replied to the thread Pretty sure I blew a head gasket this morning.....I think that based on all of the info so far, I would suggest this: Remove the thermostat. Run the engine with the radiator cap off...
-
Edelbrock replied to the thread intro and advice.Seems like you should take my profile pic.
-
Edelbrock replied to the thread Engine High Pitch Whining.It might be your blower belt. But its normal for them to make a whining noise.
-
-
Edelbrock replied to the thread Pretty sure I blew a head gasket this morning.....Ya, with any luck the coolant shorted out something in the ignition system causing it not to run. Generally speaking though, if an...
-
-
It should, frame horns are the same from 1973-1980, they changed for 1981 updated front end, those are 1981-1987(91). Might make your...
-
Hey, would a cattle guard on a 1980 Chevy K10 bolt onto a 1977 or 1978 K5 Blazer?
-
-
Get yourself some 2 AWG welding cables. Cut to fit. Amazon is your friend.
-
Anyone have any idea what battery cables would be needed for a 1977 K5 Blazer? What gauge and length? I want to have thicker cables...
-
Edelbrock replied to the thread Drive shaft too short.Ya, from the pics - what makes you fell that there is a problem? Everything looks fin to me in the pics. Every time you hit a bump, the...
-
The slip yoke should be half it's travel with the vehicle suspension supporting the sprung weight. HS
-
Edelbrock replied to the thread New to the Forum.Welcome. If that's going to be your daily, I suggest different wheels and tires. Something like this:
-
-
So I'm wanting to shorten a driveshaft to fit a 77 K5. The rig is lifted maybe 4 inches. U-Joints on either end, with a slip in the...
-
-
Edelbrock replied to the thread High oil pressure after replacing pump.The oil pressure numbers look good. I would hope that new parts would increase the pressure. As for pressure, the only possible...
