Edelbrock's latest activity
-
Edelbrock replied to the thread Pretty sure I blew a head gasket this morning.....I think that based on all of the info so far, I would suggest this: Remove the thermostat. Run the engine with the radiator cap off... -
Edelbrock replied to the thread intro and advice.Seems like you should take my profile pic.
-
Edelbrock replied to the thread Engine High Pitch Whining.It might be your blower belt. But its normal for them to make a whining noise.
-
-
Edelbrock replied to the thread Pretty sure I blew a head gasket this morning.....Ya, with any luck the coolant shorted out something in the ignition system causing it not to run. Generally speaking though, if an...
-
-
It should, frame horns are the same from 1973-1980, they changed for 1981 updated front end, those are 1981-1987(91). Might make your...
-
Hey, would a cattle guard on a 1980 Chevy K10 bolt onto a 1977 or 1978 K5 Blazer?
-
-
Get yourself some 2 AWG welding cables. Cut to fit. Amazon is your friend.
-
Anyone have any idea what battery cables would be needed for a 1977 K5 Blazer? What gauge and length? I want to have thicker cables...
-
Edelbrock replied to the thread Drive shaft too short.Ya, from the pics - what makes you fell that there is a problem? Everything looks fin to me in the pics. Every time you hit a bump, the...
-
The slip yoke should be half it's travel with the vehicle suspension supporting the sprung weight. HS
-
Edelbrock replied to the thread New to the Forum.Welcome. If that's going to be your daily, I suggest different wheels and tires. Something like this:
-
-
So I'm wanting to shorten a driveshaft to fit a 77 K5. The rig is lifted maybe 4 inches. U-Joints on either end, with a slip in the...
-
-
Edelbrock replied to the thread High oil pressure after replacing pump.The oil pressure numbers look good. I would hope that new parts would increase the pressure. As for pressure, the only possible...
-
Edelbrock reacted to TheHoundsman's post in the thread Searching for My Dad's 1979 Chevy Suburban with
Like.
As I had mentioned I am also going to try to install a cross over steering system myself. I have gotten the knuckles ready for install...
