Edelbrock's latest activity
-
Edelbrock replied to the thread Factory tach wire hole in firwall.Well, that's up to you. I generally look for an exhausting hole that was put there by the factory to feed wires or linkages through the... -
Edelbrock replied to the thread 4:10 gears for 86 k10.Nice links.
-
When i still had 31" tires, I wish I had put 4.10 gears on it. Now I'm on 32's....really wishing I did. 4l60E in mine. You go up to...
-
Edelbrock replied to the thread C10 LS Swap Actual Cold Air Intake.Nice work man. Your hired! The only things I might look at is matching the ducting diameters, h20 drain tube in the bottom of the air...
-
Edelbrock replied to the thread 4:10 gears for 86 k10.You installing a locking diff? If it were me, I would just get a complete junk yard axle that has a factory LSD. Is your rig a 4x4?
-
Edelbrock replied to the thread Shift linkage problems.I assume that you are pulling the shifter towards you when trying to get from D to P, yes?
-
They're out there. I even work with a few. More annoying are the people at the crosswalks pressing the button repeatedly thinking it's...
-
1985- automatics do not have a neutral safety switch. Went to mechanical interlock on steering column/steering wheel
-
Edelbrock replied to the thread HIT THE IGN. KEY AND NOTHING.Good to know.
-
Edelbrock replied to the thread HIT THE IGN. KEY AND NOTHING.I had a guy complaining that "the car works sometimes but not other times.... sometimes the car wont turn on". But I tried starting it...
-
Edelbrock replied to the thread HIT THE IGN. KEY AND NOTHING.If you just need a quick workaround, you can buy one of these or make one. Its just a way to manually activate the starter. On the...
-
-
Edelbrock replied to the thread HIT THE IGN. KEY AND NOTHING.Assuming its an automatic, try holding the key in the start position when moving the gear selector from P or L and back. The neutral...
-
Edelbrock replied to the thread Will a 8.5 Camaro 10 bolt axle fit in a 1981 squarebody?.If you are replacing the entire axle, I don't see how splines would matter. As long as the drive shaft will bolt up to the U-joint, then...
-
Edelbrock replied to the thread backfire under wide open throttle.One thing you could try, would be to close the choke part way and see if the problem goes away. If that solves the issue, then your...
-
Edelbrock replied to the thread Will a 8.5 Camaro 10 bolt axle fit in a 1981 squarebody?.Is your truck a 4x4? If so, that axle wont work unless you swap the front axle as well. The gearing will be different, so keep that in...
