Recent content by dmac2590

  1. D

    Noise in transmission while clutch is engaged sm465

    Dusterdude. Where is the input shaft bearing located in the transmission? All the diagrams I've looked at not one shows the input shaft bearing. Is it technically the mains gear bearing?
  2. D

    Noise in transmission while clutch is engaged sm465

    I have a whirling/grinding noise in my transmission while the clutch is out when I press the clutch pedal in its like magic and no noise. Its the sm465 4wd with I believe the np205 transfercase. I have a clutch kit including new fork and pivot ball to put in it. I'm just not sure that's going...
  3. D

    Cab harness questions/issues

    Yeah, 12v at the fuse block. I'm going to do all my body grounds I might have one that's funky. I know the connections are clean but something could be hindering the ground. I'll also do a ohms check on the block while I'm at it.
  4. D

    Cab harness questions/issues

    Only 2 of the fuses have individual power. The flashers and an auxiliary power port. I'm not sure about the block itself. I'll pull the harness from the firewall and ohm some of the connections.
  5. D

    Cab harness questions/issues

    The truck was rough when I recieved it but everything worked fine-ish, lol. I have power at the battery, starter, alternator, and junction block. Tried to stab my volt meter in the back of the wire feeding the fuse block and got 12v there. The flashers work and I have 12v to an auxiliary that...
  6. D

    Cab harness questions/issues

    I was afraid of that. I might just swap tge old harness back in and give it a go.
  7. D

    Cab harness questions/issues

    I swapped a cab on my 77 k15 for an 80 c10 cab. I plugged the engine harness in and the only power I have to the entire cab is the 4 way flashers. I've pulled every fuse in the think and checked they're all dead. Any one had this happen to them? Stock swap 350 carb engine not an LS swap...
  8. D

    Steering shaft swap questions

    Thank you I'll look into the swap.
  9. D

    Steering shaft swap questions

    No body lift sir all stock 4wd 4 speed. Cab is off a 2wd 4 speed. I tried using the shaft from the 80. I thought it should telescope but it won't budge at all. I'll tru blasting it with some Kroil and see if it's just gunned up by chance.
  10. D

    Steering shaft swap questions

    I just put a complete 80 cab on my 77 k15 frame, and the steering shaft is too short. Would everything fit in if I just reuse the steering column for the 77 cab? I wanna get some clarification on this before I start to yank the columns out or spend extra money on a new steering shaft. Thanks all.
  11. D

    77 K10 Cab swap questions

    Late to the party here. I'm doing the same swap. I have a 77 chassis and need a cab. I found a real nice cab off an 84. Mine truck is 4wd with the 4 speed. Besides the trans hump, will my fenders and hood bolt up? Will the wire harness connections work for wiring? I'm in dire need of some...
See more

Latest posts

Forum statistics

Threads
42,250
Posts
912,194
Members
33,754
Latest member
SquareInheretance
Top