-
-
DDleslie212 replied to the thread Interior Journal.Good info, thank you. Luckily, so far anyway, all the welding I have to do except one small spot on the outside of the rocker will be...
-
DDleslie212 replied to the thread Interior Journal.Cab floor support is trash
-
DDleslie212 replied to the thread Interior Journal.
-
-
DDleslie212 replied to the thread Interior Journal.It doesn't look like the new pans will reach up that curve of the seat hump so I'll have to figure out what to do there Also, those...
-
-
DDleslie212 replied to the thread Interior Journal.
-
-
DDleslie212 replied to the thread Interior Journal.Cut out some of the rot today on the driver side. I have floor pans here, the rockers are on order from LMC. The rocker isn't as bad...
-
DPurchased for $3200 about 5 years ago Everything listed below has been performed by myself within last few years, with less than 500...
-
DDleslie212 replied to the thread Interior Journal.For some reason the driver side floor pan picture didn't upload, but it's the worst of it. There are several small chunks of metal...
-
DDleslie212 replied to the thread Interior Journal.
-
-
DDleslie212 replied to the thread Interior Journal.
-
-
DDleslie212 replied to the thread Interior Journal.
-
-
DStarting on interior. Today I pulled the bench seat the floor matting and padding. Found a few ventilation holes in the floor pan. Looks...
-
DDleslie212 replied to the thread No power at all, zero lights, guage lights, or anything else. Any help wld be great..Did you install a shim on your starter? If so you may want to remove it and try again, sounds like the starter is too far away from the...
-
DDleslie212 replied to the thread Dakota Digital RTX Install Critique.For future readers - water temp and tach both get fed thru the PF4 BMI and outputs directly into the DD gauges so no need to run the...
-
DDleslie212 replied to the thread Dakota Digital RTX Install Critique.Finally started mine today after having it sitting in a box for almost 2 years. SquareRoot - what all did you NOT use on your setup...
-
-
Loading…
-
Loading…
