Designo614
Latest activity Postings About
-
-
I have never had any success painting plastic parts. I have followed the guidance found everywhere: scuff sand, clean with grease... -
Designo614 replied to the thread 454 original value add for a square body.Did for me, but mine's a tow rig, so the added torque ought to be meaningful.
-
Designo614 replied to the thread Holy Grail of Squarebodys.Squarebody Holy Grail? Hmmm... maybe a 454, SM465 1 ton dually with an 8 ton crane on the back-
-
-
Designo614 replied to the thread No gas to carb.Vapor lock is caused by the fuel in the lines turning turn to vapor because of excessive heat, essentially boiling it. This happens when...
-
Designo614 replied to the thread Quadrajet from hell will not give me peace.I'm in a G-body group for my '87 El Camino, which came stock with a 305 with a Rochester Quad. I have seen many people comment that...
-
Designo614 replied to the thread SM465 / Clutch.Turbo4whl, thanks. I haven't installed any clutch parts other than the master and slave cylinders, and I don't know how old or worn any...
-
Designo614 replied to the thread SM465 / Clutch.Thanks. I feel better about the slave cylinder travel now, i appreciate you verifying on yours. I verified that the plunger does move...
-
As far as getting it out it is a heavy sob! I took mine out with the transfer case still installed using a floor jack and a cheap Harbor...
-
Your pto shouldn't be running while going down the road. So that could be an issue, also i think you should have a little more than an...
-
The clutch wouldn't be the problem. I once drove my truck home from a day of four wheeling without a clutch when the clutch rod broke...
-
The PTO should disengage with the floor plunger. I would crawl under the truck and make sure that the external linkage is moving with...
-
I used a handpump to get the fresh oil into the transmission. The one I had was designed for the lower unit on an outboard motor. It...
-
I have found that a submersible 12v bilge pump moves hydraulic fluid nicely, but it has a 5/8" outlet. I bet if you were to cut the top...
-
I just buy those 5 dollar hand transfer pumps from Walmart. They work great as long as you don’t use gorilla strength like I did one...
-
So, my new to me 1988 1 ton with a Holmes wrecker body on her, and shifting issues continue. Here's what it's doing, and here's what...
-
-
Loading…
-
Loading…
