Recent content by custodian
-
-
Putting a gas 350 in a 6.2 diesel frame, quick input please.
I put a 350 in my 85 C10 short bed that had the 6.2 diesel. I used the stock diesel clam shells and motor mounts. I took all the diesel related stuff off. I used the two glow plug wires as 12V to the HEI distributor and anything else that needed switched 12v. I removed the hydroboost system and...- custodian
- Post #13
- Forum: Diesel 6.2, Conversions Cummins, etc.
-
Lost Fuel Pressure
I was hoping too. Going the grease on the push rod route and maybe a a small screw driver to hold it up.- custodian
- Post #17
- Forum: Carb Fuel Systems
-
Lost Fuel Pressure
I don't think there is a bolt on the front of a BB 454 like the the SB 350 to hold the fuel pump rod in the up position.- custodian
- Post #14
- Forum: Carb Fuel Systems
-
-
-
Lost Fuel Pressure
I did some testing this morning. I used a fuel pump that I use to crank LS motors and hooked it up to the fuel line coming from the transfer switch. I was able to pull gas from both sides. I then put a fuel line into a small gas tank to the fuel pump and tried to start the truck, no luck. SO...- custodian
- Post #6
- Forum: Carb Fuel Systems
-
Lost Fuel Pressure
Yes, mechanical pump on the motor, 454, and no fuel when I removed the inlet line to the pump.- custodian
- Post #3
- Forum: Carb Fuel Systems
-
Lost Fuel Pressure
I was driving my 86 Dually home after putting some gas in the drivers side tank and it just cut off. Had my wife come and pull it home. I poured some gas in the carb and it run. I removed the fuel inlet at the carb, no pressure, and put an empty clear bottle on the end of the line and turned the...- custodian
- Thread
- Replies: 23
- Forum: Carb Fuel Systems
-
Quadrajet Idle Mixing Screws
I took the carb loose and sprayed them with PB Blaster. They turn now.- custodian
- Post #4
- Forum: Carb Fuel Systems
-
Quadrajet Idle Mixing Screws
My idle mixing screws will not turn on my 86 C30 with a 454.- custodian
- Thread
- Replies: 3
- Forum: Carb Fuel Systems
-
3 Wire Temp Sender
I'm doing an LS Swap in the 85 C10 with gauges. How can I wire the 3 wire temp sender from a 97-98 Corvette/Trans Am be used/replace the one wire temp sender and still use the gauge in the 85 C10?- custodian
- Thread
- Replies: 3
- Forum: Engine Swaps (Gas) LS, Vortec, LT1 , etc.
-
Cruise Control Wiring
I have an 85 C10 that I'm doing an LS swap and want to use the cruise control wiring to send the VSS signal to the computer. There are five wires. Just not sure what each wire is for. I've looked through the wire harness section and couldn't find the plug that I have. I'll post pictures of the...- custodian
- Thread
- Replies: 1
- Forum: Tech Discussion
-
1973 Impala/Caprice gas pedal
Yes, I'm doing an LS swap in the 85 C10 and going to hook the detent cable to the gas pedal. -
1973 Impala/Caprice gas pedal
I'm looking for a 73 Impala/Caprice gas pedal. I've already looked on ebay.
