Craig Nedrow's latest activity
-
The correct shims between the spindle and the knuckle for Camber. Is it loose or is it sticking from side to side and you have to... -
You need to get the toe correct, toe out will make them quick steer no matter which way you twitch the wheel. You need to verify caster...
-
Don't forget the leaf springs are what keep the axle in position. If you have a broken center pin, or worn bushings at either end of...
-
Get it aligned. There's more to alignment then toe,and eye isn't usually an accurate way of setting toe.
-
And if the alignment tech is a good one he may just find some other problem(s). Mine was pretty bad until I replaced the stabilizer...
-
Craig Nedrow reacted to TotalyHucked's post in the thread What would you pay for this truck? with
Like.
I know everybody has a different budget but it would be well worth saving a few more pennies to start with a better truck. That's a $500... -
Craig Nedrow replied to the thread Pretty sure I blew a head gasket this morning.....Good advice from Eric, also sounds like a head gasket leak. You can check this when you get it home. Fill back up with water, start it...
-
Craig Nedrow reacted to Bextreme04's post in the thread Pretty sure I blew a head gasket this morning.... with Like.
My first thought is that you should make sure you didn't lose a hose somewhere. All of your symptoms could have been from an air bubble...
-
Craig Nedrow reacted to Ricko1966's post in the thread High oil pressure after replacing pump with Like.
My concerns with running excessive oil pressure would be holding the bypass valve open in the oil filter so you are no longer filtering...
-
Craig Nedrow replied to the thread 4:10 gears for 86 k10.Randy's worldwide the home of Yukon gear, been using there stuff for a long time, Go Here: https://www.randysworldwide.com/ Here is my...
-
Spencer is right. I'd never tackled a re-gear/axle rebuild before and decided to re-gear my '05 Silverado. I ordered the kit from Quick...
-
Gotcha. Personally, I'd go deep on the gears because parts are too expensive to wish you had done more when it's done. If you're not...
-
When i still had 31" tires, I wish I had put 4.10 gears on it. Now I'm on 32's....really wishing I did. 4l60E in mine. You go up to...
-
@Rjckey do you have an overdrive transmission? If yes, I'd go with 4.56's (I used this combo in my old crew cab, it drove great). If you...
-
OP said k10, so 4x4. If you aren’t doing the work yourself, I’d find the shop that’s doing it first. They’ll have a supplier they like...
