Craig Nedrow's latest activity
-
Craig Nedrow reacted to Ricko1966's post in the thread Update on my Ignition Module failure! with
Like.
I don't buy distributors I use genuine GM,AC Delco gold,or NAPA premium modules. I reuse/ rebuild,find new old stock, as much as... -
Craig Nedrow reacted to Ricko1966's post in the thread Update on my Ignition Module failure! with Like.
I only recommend genuine gm,delco gold or NAPA premium. To the best of my knowledge those are the only modules that hold true to the...
-
Craig Nedrow reacted to Goldie Driver's post in the thread Update on my Ignition Module failure! with Like.
I had a USA made Borg Warner HEI module crap out in a month or so. The replacement AC Delco is still going so it's the only replacement...
-
Adrian While trying to get this sorted out you should leave it connected to manifold vacuum for sure. By the vacuum number you mentioned...
-
Craig Nedrow reacted to Ricko1966's post in the thread BBC 396 wil not idle with any carb with Like.
If you can't get it to idle you can't set timing anyway, so put it where ever it runs best for now. If the rpms are too high the weights...
-
Craig Nedrow reacted to Ricko1966's post in the thread BBC 396 wil not idle with any carb with Like.
New O.E means nothing at this point,different engine,different carbureator,different intake,camshaft,etc. put it on manifold vacuum,you...
-
Craig Nedrow reacted to Ricko1966's post in the thread BBC 396 wil not idle with any carb with Like.
Have you checked fuel delivery,if it will take throttle with choke closed,you either have not enough fuel,or too much air. See how much...
-
Craig Nedrow replied to the thread Frame & undercarriage advise!.Here is a link to the 73 and what it took ME, not you to do what I did...
-
Craig Nedrow replied to the thread Frame & undercarriage advise!.My 85, used Duplicolor, go here:https://www.gmsquarebody.com/threads/new-for-me-1985-silverado-20-6-2-diesel.32359/page-6 post 8. On the...
-
-
When I did the LS swap on my truck, I wire brushed and painted the front half of frame while the drivetrain was out. I used VHT Chassis...
-
Imho for a driver, just keep it cleaned fairly often and hit it with spray paint, as needed. The heavier and stronger coatings tend to...
-
Craig Nedrow replied to the thread AFR gauge installation.I did the same install, go here start on post 108: https://www.gmsquarebody.com/threads/1973-k20-350-to-454-swap.29840/page-8 An amazing...
-
It's officially working! Almost in disbelief lol, not done yet but definitely getting closer.
-
American autowire. Forgot that part.
-
Craig Nedrow replied to the thread BBC 489 build.The oil pan has some nice hardware, and is double bolted, so bolts cannot loosen. I think this is a pretty engine, but pretty is what...
-
